Review of etrailer 4 Leaf Slipper Spring - e69SR Video

Hey Michael, the Kenda 5.30-12 Bias Trailer Tire #AM30710 has a K-65 mph sped rating.

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

The 4-Leaf Slipper Spring w/ Radius End for 2,000-lb Trailer Axles #e69SR should be compressed ~2" under a 1,000 lb load which would make the "F" measurement ~1 3/4" with the 1,000 lb load. This is based on a formula to find…

Your question came in totally blank, all I got were a couple pictures of a drop spindle axle on top of a leaf spring with the U-bolts removed. If you are having difficulty separating the leaf spring from the axle you might try some penetrating lube…

I do have an option for you but the Dexter Trailer Springs Over-Under Conversion Kit part #K71-384-00 is for axles with a 2-3/8" diameter as they measure about 2-3/8" inside to inside so it likely will not work with a 2,000 lb axle which…

To choose a compatible hub assembly for any spindle the key is knowing the inner and outer bearing part numbers, or if they are not available, precise dimensions of the spindle at the points where the bearings and grease seal ride. These points on…

Nope, there is not any type of plastic wear bad to go between the 1-3/4" wide 3-Leaf Slipper Spring w/ Flat End for 2,900-lb Trailer Axles - 30" Long #e49SR and trailer frame.

You can use springs with a lower capacity than your existing springs to help provide an easier ride for your PWC. The #SP-178275 springs are a great choice. It is important to keep in mind that going with a lower weight rated spring will reduce the…

It can be a flat end as long as the flat part is long enough that it can reach past the wet bolt just fine. For your application it looks like the 4-Leaf Slipper Spring w/ Radius End for 2,000-lb Trailer Axles #e69SR is the closest that we have as…

Since you do not want to use an over/under kit on your axle, the best way to raise the trailer would be to use longer hangers for the leaf springs. You may be able to use a hanger like part #E4139. This hanger is designed for double-eye springs and…

The bolts for the mounting hardware that comes with the Round Swivel Marine Jack w/ Wheel #MJ-1500B have an overall length of 4 1/4" and the thread is 3/8-16 course threaded. If you are needing new hardware for this jack then we actually have…

The 60/40 axle placement formula is a great starting point and does take into account the tongue of the trailer from where the trailer sits on the hitch ball. Please keep in mind that this is a very basic formula or estimate for axle placement. For a…