CE Smith Bolster and Swivel Bracket Assembly for Roller Bunks - Galvanized Steel - Qty 1

Video Transcript for Review of CE Smith Boat Trailer Parts - Roller and Bunk Parts - CE10003G

Today, we're going to take a look at the CE Smith 11 inch long galvanized steel bolster and swivel bracket assembly for roller bunks. It's for a quantity of one. This bolster and swivel bracket assembly will let you mount a roller bunk on your boat trailer. The bracket assembly is typically mounted upright on your boat trailer's cross members, and it allows a mounted roller bunk, which is run from the front of the trailer to the back, to pivot while you're loading a boat. The swivel brackets let you tilt the roller bunk, helps you to fit the boat hull snugly onto the trailer during the loading process. You can see the bolt and lock nut is included that attaches the swivel bracket to the bolster bracket.The swivel bracket end is what will bolt to the roller bunk, and the bolster bracket is what attaches to your trailer frame cross members.

You can see it has two long mounting slots here on the bracket to allow as much as 3-3/4 inch of height adjustment when you're installing it. That bracket does install vertically on the boat trailer's frame using a U bolt. The U bolt is not included, that is sold separately. Basically, when you go to install this, you'll put your U bolt through there and then just adjust it up or down to whatever height you need directly on your boat trailer.If you notice on this side here, it does have a dimpled surface on this bolster bracket, helps prevent the bracket from sliding along the trailer frame after it's installed. So once you find the correct height and bolt it down, those dimples on there will keep it from moving on the trailer frame.This is an 11 gauge galvanized steel, helps resist rust and corrosion.

It is suitable for salt water exposure. This is for a quantity of one bracket assembly. The overall height from the bottom to the top of the swivel bracket is right at 11 inches tall. Now, dimensions on just the bolster bracket, the height on that is going to be 10 inches tall, the width on it right at 2-1/2 inches wide. The mounting slots, there's two of them there, it's going to be a 1/2 inch wide, and the height on them or length of them is going to be right at 3-3/4 inches long.

The swivel bracket itself, the width on it is 1-3/4 inches, the length is 1-1/4, and the overall height of just the swivel bracket, from the bottom of it to the top it 2 inches tall. The mounting hole diameter right here is 7/16 diameter.That should do it for the review on the CE Smith 11 inch long galvanized steel bolster swivel bracket assembly for roller bunks for a quantity of one.