Trailer Brake Controller Installation - 2008 Jeep Liberty Video

You want to make sure the hitch ball is out past the furthest point of the truck. An 18 inch extender like the Curt #C45796 will reach most of the way to the edge of the truck. Then any ball mount will make up the rest. We have a ball mount kit,…

If you are installing a 7-way and brake controller you will want to use a circuit breaker in-line when connecting the Black wire from the 7-way to the battery and in-line from the brake controller to the battery. The Black wire will draw 12 volt…

I took a look at the owner's manual for the 2012 Jeep Grand Cherokee Laredo V6 3.6L. The 3.6L engine Grand Cherokee can tow a 5,000 lb trailer. That figure is the gross weight so that would include all of the cargo inside the trailer. You want to…

The smallest wheel diameter we offer that is for hubs that have a 5 on 4-1/2 inch bolt pattern is 10 inches. The smallest tire size then would be the 205/65-10 that measures 20.5 inches like the part #AM3H490.

To install a 7-way on your 2005 Jeep Liberty you will first need to start with a 4-way like part #C55382 and then from there convert it to a 7-way. If your trailer doesn't have brakes and all you need is lighting functions then all you would need…

On your 2007 Jeep Liberty, If you are referring to the red wire on the brake controller, it attaches to the wire on the stoplight switch that carries a signal only when the brake pedal is pressed. You will need a circuit tester, like #PTW2993, to…

I recommend using the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector #HS381-9000 to start off. This gives you a 7-Way connector and a clean and organized way to connect all of your wiring. Then for the wiring for…

The blue electric brake power feed wire should be connected to the terminal in a 7-Way RV style connector, at the 7 o-clock position when looking at the inside of the connector. If looking at the outside of the connector the terminal is in the 5…

To install a brake controller in your 2006 Jeep Liberty with a factory 7-Way you will need to hardwire the wires from the back of the brake controller to the vehicle. This vehicle does not have a brake controller port that you can plug the brake…

A 1995 Chevy 3/4 Ton Van has a towing capacity between 7,068 and 10,000 lbs. You will need to look at your owners manual for more specifics on your unique vehicle. There will also be a sticker inside the driver's door jamb to give you information…

To flat tow a vehicle, you need a tow bar, base plates that mount to the vehicle and provide an attachment point for the tow bar, safety cables, a lighting solution and a supplemental braking system. The base plates I recommend for your 2003 Jeep…

The Tow Ready Vehicle To Vehicle Taillight Converter, #118158, you have referenced will not be needed since you will be staying with a 3-wire system (separate stop and tail lights)on both of your vehicles. The converter is only needed if you had a…