Review of etrailer Trailer Hubs and Drums - Hub with Integrated Drum - AKHD-5475-35-EZ-K Video

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

The Trailer Hub and Drum Assembly part #AKHD-545-35-EZ-K would be an excellent replacement for a Tru-Ryde Hub/Drum RVD-H-545. Then for new brakes, I recommend the Hydraulic Trailer Brake Kit part #AKFBBRK-35.

I currently have three diffrent self-adjusting assemblies for your boat trailer with 10" x 2-1/4" electric drum brakes which are attached for you below. eTrailer Electric Trailer Brake Kit part #AKEBRK-35-SA (3,500 Axles) Dexter…

I have a few options depending on if your Atwood actuator is for disc brakes or drum brakes. For drum brakes I recommend the Titan Brake Actuator with Manual Lockout - Bolt On - Drum - 2" Ball - 7,500 lbs #T63FR which is the only actuator we…

The Electric Trailer Brake Kit - 10" - Left and Right Hand Assemblies - 3,500 lbs #AKEBRK-35 has a mounting pattern that is typical for 3,500 lb axles. The center on center horizontal measurement of the mounting bolts are 2-7/8 inches and…

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

Since Atwood went out of business none of their actuator (or other product) replacement parts are available unfortunately, so your only real option to having a working actuator is to replace the entire unit. I am attaching a link to our selection of…

When bleeding the brakes on your trailer after installing the Kodiak Calipers you will first want to start with the brake that is furthest away from the actuator. Of the two bleeder valves, you will want to the bleeder valve that is on the top of the…

Most brake actuators for drum brakes like your Dico 6000 lb cannot be used for disc brakes. This isn't based on weight capacity, but rather based on the pressure the master cylinder can handle. Most drum brake systems give you 1000 to 1200 psi,…

The Demco Hydraulic Brake Actuator w/ Electric Lockout #DM62VR does not hold residual pressure in the brake line when the surge brake is not being pressed. This will allow you to use it with the Kodiak disc brakes on your trailer.

Minus the packaging, the Demco #DM62VR Hydraulic Brake Actuating Coupler weighs about 18 lbs. The coupler is compatible with trailers weighing up to 7000 lbs with disc brakes. The coupler fits a 2 inch trailer ball, and is equipped with an electric…

Surge brakes do not have any adjustability. If you want to use them on steep hills your solutions would be best. Or you can look into an electric over hydraulic setup which will allow you to use a brake controller to activate the brakes. This gives…