Review of etrailer Trailer Hubs and Drums - Hub with Integrated Drum - AKHD-5475-35-K Video

For the broken brake assembly the TruRyde kit part #TRU36FR would be your best option for a self adjusting brake set that comes with a replacement left and right hand side assembly. Then for replacement hub/drums you'd want the part…

The spindles of an EZ lube axle are the exact same as a non-EZ-lube. Only difference being the zerk fitting at the end of it. The EZ lube hubs we offer are the same as the non-EZ-lube hubs with the only difference being the grease cap has a rubber…

I am glad you asked these questions. First, to tow a trailer level you need only a ball mount with the proper rise or drop. I have included a link to our FAQ article that explains how to measure for rise/drop and a link to our ball mount main page.…

Typically trailer wiring is color coded. The brake circuit is usually a blue wire which travels to each brake magnet, where it is attached to one wire from each brake magnet. The other wire from each brake magnet will ground to the trailer frame. I…

The studs on the Dexter 7 inc brake assembly, part #23-47, are 1-1/4 inch long with 7/16 - 20 threads. Brake Assembly mounting bolt, part #7-75, is 1-1/4 inch long with 7/16 - 20 threads. The nuts, part #6-17, are also 7/16 - 20. This size is…

Self adjusting brake assemblies like the part #AKEBRK-35-SA do not require initial adjustment but you'll need to apply the brakes several times while moving slowly to allow them to self adjust to the correct tension. They will feel pretty…

The brake controller install harness on your 2022 Jeep Grand Cherokee 4xe is under the dash, to the left of the steering column, taped to another harness near the emergency brake pedal. The Tekonsha brake controllers like the Prodigy P3 part #90195…

Self-adjusting brake assemblies are the way to go like with the #AKEBRK-7-SA which do fit your 7k Dexter axles. The only real reason to go with manual adjust is really just cost. At one point the self adjusting models were much more expensive but now…

I have included a picture that shows where you will want to measure the spindle. Measurements need to be as accurate as possible so I recommend using dial or digital calipers to take the measurements. If the other hub is still present you could pull…

Nearly all 2,000 lb axles have a spindle that is 1 inch in diameter where both bearings ride. If that's what you have then the bearing kit part #BK1-100 would be what you need as it fits that spindle.

I can help you with greasing up your EZ Lube Axle. First thing I would check would be that the grease is not coming out of the back of the axle through the seal. If this is the case you will need to replace the seal. Our tubes like #L11390 have 14…

The Dexter bearing kit part number K71-717-00 that you referenced is the bearing kit for a number 84 spindle. Our part number for that bearing kit is #BK2-100.