etrailer Adjustable Trailer Coupler - Coupler Only - CTA-296 Review Video

You're not going to have any problems mixing Dexter and Lippert components on trailer axles over 10k-lbs in the same manner as below 10k-lbs as long as the measurements on the replacement parts are the same- i.e. bearing sizes are the same,…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

We have a folding trailer tongue hinge that could work for the purpose you describe, as long as your trailer frame isn't constructed of aluminum. You could use the Fulton Fold Away Coupler Hinge, part #FHDPW330300. The hinge kit is designed for 3…

I spoke to my contact at Bulldog and they cannot recommend substituting the grade 8 bolts that came with the coupler for a set of hitch pins. This would void the warranty of the coupler and more than likely a few SAE requirements. If you choose to do…

Since the Demco Hydraulic Brake Actuator #DM8759812 is a DA91 actuator the Reverse Lockout Solenoid Kit #DM5837 will fit. I confirmed this with my contact at Demco.

The Sleeve-Lock Trailer Coupler part #CTA-296 which is designed to be used with something like the Ram 3-Position Adjustable Channel Bracket part #CTA-CB4 measures 9-7/8" from the center of the mounting holes to the tip of the coupler. That…

The Demco 6-Hole Adjustable Channel Bracket - Weld On - 12" Tall - 21,000 lbs #DM66134 is the weld on option for your trailer. There isn't a complete kit we offer, but it sounds like you are seeking the Demco 50-Degree A-Frame Coupler…

Judging from the photo, it does look like the #DX44FR that you were looking at is the correct replacement part you need. This is the replacement master cylinder for the A-60, A-75, A-84, A-160, A-200, XR-84 and XR-200 series of Dexter actuators, in…

The mounting bolt holes on the Demco Hydraulic Trailer Brake Actuator #DM72VR that you referenced are spaced apart exactly 3 inches, on center. From the center of the rear bolt hole to the end of the unit there is a distance of just under an inch…

I have attached for you below a photo which shows the bolt pattern for the Demco Hydraulic Brake Actuator part #DM72VR.

159 ft lbs of torque would be the torque figure needed when tightening the hardware that secures the Sleeve-Lock Trailer Coupler #CTA-296 to the channel.

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…