Dexter Trailer Springs Over-Under Conversion Kit Installation K71-384-00 Video

The Dexter Trailer Springs Over-Under Conversion Kit like part #K71-384-00 does not require welding. That said, it is recommended to tack the spring seats to the axle but this is super easy to do even for someone with no prior welding experience.…

Yes, if you wanted to drill a different hole in your trailer suspension rear hangers you could and this would allow the spring to be held at a different height. Just make sure it's not too close to the current hole.

In the past we've found that the trailers that have 31 inch wheelbases use the equalizer #TREQ104 so based on that the correct kit you'd need would be the part #AP233.

Hey Ronald, the landing gear part #RVLG-8HDL does not come with new brackets but we have them available with the part #LG-Brackets. These will need to be welded on as there isn't a way to bolt on the jacks to the brackets you have now.

There is always a way to make it work. I can't recommend doing that as I have not tested it and I do not offer a product like that with the exception of the Dexter Trailer Springs Over-Under Conversion Kit part #K71-384-00. This will give you…

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

What you need is the Correct Track tandem lift kit part #RR23QX which will give your current suspension setup a lift of up to 2-1/4 inches. Aside from that there isn't a way to gain additional height from the trailer.

Hi Shane; for an over/under kit for your 2-3/8" diameter trailer axles what you will need is the following: - Dexter Trailer Springs Over-Under Conversion Kit #K71-384-00 Keep in mind this kit is for a single axle only, so for a tandem axle you…

The Timbren Trailer Suspension Enhancement System for Underslung Axles #T92MR is 5-1/4" tall. Timbren recommends The spring be in constant contact with the frame at all times. So ideally you will want exactly 5-1/4" from your axle tube to…

Ways to raise the height of a trailer for better ground clearance include using larger wheels/tires and installing an axle over-under kit that reverses the placement of the springs and axle. An axle over-under kit (we offer two) will give you a…

We do have a spring that will be a suitable replacement for your 708-no500 leaf spring. Our springs will be 26" eye to eye, but a 1/4" difference will not effect anything and will be completely fine to use as a replacement. We have them…

It is highly recommended that the spring seat be at minimum tack welded to the axle. There have been issues that have resulted from the seat not be welded to the axle. If you do not have access to a welder, I recommend taking the trailer to a local…