Review of etrailer 2 Leaf Slipper Spring - e29SR Video

It is possible to replace your 62" long axle with a longer one. Our next size up is going to be a 72" long 2K rated axle like part #e32GR. The axle being 72" across measured from hub-face to hub-face. This axle comes with 5…

The 3 inch shackle bolt part #166081 would be a great option to use with the CE Smith suspension hanger part #CE14016G. This would be a better fitting size than going with the longer 3.5 inch bolt you mentioned.

I completely understand your troubles and confusion with leaf springs. First do remember there are different types of spring steels so the thickness of the leaves is not always the best way to judge the weight capacity for the leaf springs. So while…

Yes the slipper spring part #e29SR that you referenced can install below the trailer axle. I attached a picture that shows it installed in this orientation.

The length of the slipper spring is from the center of the eye to the end of the slipper. See the attached diagram below. The width and the capacity are also necessary when choosing a replacement, leaf count isn't very important and can vary. The…

It could just be the angle but looking at the picture you attached it appears that you have a 1-3/4 inch diameter axle. This would be consistent too with the smaller 2,000 pound axles that are typically on jet ski trailers like what you have. I do…

The etrailer Axle #e32GR uses a Easy Grease Trailer Idler Hub Assembly #AKIHUB-545-2-EZ-2K which will use the Bearing Kit #BK1-150. I do recommend pulling one of your hubs apart to verify that the bearings and seals match the spindle on your axle.…

For a slipper spring that would work well for your application you would want the part #e29SR. This is a 2k rated spring that is 30-1/4 inches long. This should be a much softer spring than what you have as it looks like your spring would be a higher…

The etrailer brand axle #e32GR is pre-greased using a lithium complex multi-purpose grease like the #DX64TR.

I would be happy to help you find the correct replacement springs for your Continental AWC11e Trailer, but unfortunately we do not have a break down of the specific components your trailer uses. To determine the correct replacement spring you will…

Nope, the slipper spring rear hangers like the part #CE14017G do not require the use of a bushing between them and the spring. I attached a picture that shows how it will look when it is installed.

Yes, you would want the hangers used for installing the Slipper Springs part #SP-179275 that you referenced to be 23-1/8 inches apart when installing these springs on your trailer. I attached a review video for you to check out and a help article on…