U-Bolt Kit for Smaller Round Axle on Jet Ski Trailer
Question:
I must have an oddball size axle on my jet ski trailer. It is 2” in diameter and round, not square. I can’t seem to find 2” between the legs U bolts. Will 2-3/8” U bolts work with a 2” axle when torqued down?
asked by: Andrew
Expert Reply:
It could just be the angle but looking at the picture you attached it appears that you have a 1-3/4 inch diameter axle. This would be consistent too with the smaller 2,000 pound axles that are typically on jet ski trailers like what you have.
I do recommend verifying this measurement once more but if this is indeed the case then you can use the CE Smith U-Bolt Kit # CE23000 which features U-Bolts with an inner width of 1-7/8 inches and galvanized plates to resist any rust or corrosion. I have attached a video review that you can also take a look at.
I do not recommend using larger 2-3/8 inch U-bolts as this is going to allow for too much movement.
Products Referenced in This Question
CE Smith U-Bolt Kit for Mounting 2,000-lb, Round Trailer Axles - 4" Long U-Bolts - Zinc
- Trailer Leaf Spring Suspension
- U-Bolt Kits
- Boat Trailer
- Snowmobile Trailer
- 2000 lbs
- Round Axle - 1-3/4 Inch
- 3/8 Inch Diameter
- 4 Inch Long
- CE Smith
more information >
Product Page this Question was Asked From
U-Bolt Kit for Mounting 3,500-lb, Round Trailer Axles - 5-1/2" Long U-Bolts
- Trailer Leaf Spring Suspension
- U-Bolt Kits
- Camper
- Car Hauler
- Utility Trailer
- 3500 lbs
- Round Axle - 2-3/8 Inch
- 1/2 Inch Diameter
- 5-1/2 Inch Long
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Video: CE Smith Trailer Suspension CE15285GA Review
- Video: etrailer Easy Grease Spindles Trailer Axle Beam Installation
- Video: CE Smith U-Bolt Kit for Round Trailer Axles Review
- Video: Redline Trailer Suspension - Leaf Spring Suspension - APS3SE Review
- Q&A: How to Determine Correct Replacement Slipper Springs
- Shop: Submersible, Under 80" Trailer Light Kit with 25' Wiring Harness
- Shop: Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 60" Long - 2,000 lbs
- Shop: Standard Trailer Light Kit with 25' Wire Harness
- Shop: 1-3/4" Round Trailer U-Bolt (Qty 2)
- Shop: 2-Leaf Slipper Spring w/ Flat End for 1,800-lb Trailer Axles - 30" Long
- Shop: CE Smith U-Bolt Kit for Mounting 2,000-lb, Round Trailer Axles - 4" Long U-Bolts - Zinc
- Shop: U-Bolt Kit for Mounting 2,000-lb, Round Trailer Axles - 4-1/4" Long U-Bolts
- Shop: Trailer Hitch
- Search Results: axle
- Article: Trailer Wiring Diagrams
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Shop: Trailer Wiring
- Search Results: trailer jack
- Article: Trailer Tire Sizing
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Brake Controller
- Search Results: trailer lights
- Article: Most Popular Wheel Bearings
- Q&A: How to Determine Weight Capacity of Trailer Axle
- Search Results: bearing buddy
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What is the Difference Between Load Range C and D ST175/80D13 Trailer Tires
- Shop: Suspension Enhancement
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
on Trailer Leaf Spring Suspension
