TruRyde Trailer Suspension TRFA71063 Review Video

It is possible to replace your 62" long axle with a longer one. Our next size up is going to be a 72" long 2K rated axle like part #e32GR. The axle being 72" across measured from hub-face to hub-face. This axle comes with 5 on…

The 3 inch shackle bolt part #166081 would be a great option to use with the CE Smith suspension hanger part #CE14016G. This would be a better fitting size than going with the longer 3.5 inch bolt you mentioned.

I completely understand your troubles and confusion with leaf springs. First do remember there are different types of spring steels so the thickness of the leaves is not always the best way to judge the weight capacity for the leaf springs. So while…

The #42 E-Z Lube 4" Drop Spindle w/ Flange for 5.2K to 7K Trailer Axles #TRU39FR is the same size as that used on the Dexter Trailer Axle Beam with 4" Drop E-Z Lube Spindles #8327860. Both will fit the same Dexter Trailer Hub and Drum…

It really depends on the springs used. Take a look at the picture I have included that shows hanger spacing based on several different springs. This will be a good guide to reference when mocking up the suspension on your trailer. This is also found…

You will actually just need kit #APT6SE-36 which is the same thing only the equalizers in it are 13-1/8 inches long. The hardware with each is specific to the kits so some of the other parts are different but for 2 inch slipper springs and 13-1/8…

I have another option for you but there is not a screw on spindle available for the #8327872 you were looking at. To replace one of the spindles on the Dexter Trailer Axle Beam with 4" Drop E-Z Lube Spindles - 94" Long - 7,000 lbs #8327872…

You will need a heavy-duty winch in order to pull a 13,000 lb skid loader onto your trailer, and we do have a really good option. Assuming your skid loader is going to be a rolling load instead of a static load, you can use a winch with a line pull…

It could just be the angle but looking at the picture you attached it appears that you have a 1-3/4 inch diameter axle. This would be consistent too with the smaller 2,000 pound axles that are typically on jet ski trailers like what you have. I do…

I reached out to the manufacturer and the Wet Equalizer Bolt with Locknut and Grease Zerk for Double-Eye Springs - 3-5/16" Long #126B2 is a pressed in zerk fitting, so it cannot be replaced. There are not threaded zerk fittings available for…

The term, wet, in this case means that the head of the bolt has a grease Zerk in it and there is a channel that leads to center of the bolt. This makes it easy to grease the bolt while installed, as you can put a grease gun right up to the Zerk and…

The Wet Equalizer Bolt with Locknut and Grease Zerk for Double-Eye Springs part #126B2 has a grade 5 rating. There are three radial lines on the head of the bolt which indicates the rating.