Redline Round Trailer Axle U-Bolt Mounting Kit Review Video

It is possible to replace your 62" long axle with a longer one. Our next size up is going to be a 72" long 2K rated axle like part #e32GR. The axle being 72" across measured from hub-face to hub-face. This axle comes with 5…

The 3 inch shackle bolt part #166081 would be a great option to use with the CE Smith suspension hanger part #CE14016G. This would be a better fitting size than going with the longer 3.5 inch bolt you mentioned.

I completely understand your troubles and confusion with leaf springs. First do remember there are different types of spring steels so the thickness of the leaves is not always the best way to judge the weight capacity for the leaf springs. So while…

The etrailer brand axle #e32GR is pre-greased using a lithium complex multi-purpose grease like the #DX64TR.

All axles, including the Trailer Axle with Idler Hubs #e25GR you referenced, are measured by capacity and two measurements (hub-face to hub-face & spring center to spring center). The hub-face to hub-face measurement ensures that your wheels will…

It could just be the angle but looking at the picture you attached it appears that you have a 1-3/4 inch diameter axle. This would be consistent too with the smaller 2,000 pound axles that are typically on jet ski trailers like what you have. I do…

Yes the slipper spring part #e29SR that you referenced can install below the trailer axle. I attached a picture that shows it installed in this orientation.

The etrailer Axle #e32GR uses a Easy Grease Trailer Idler Hub Assembly #AKIHUB-545-2-EZ-2K which will use the Bearing Kit #BK1-150. I do recommend pulling one of your hubs apart to verify that the bearings and seals match the spindle on your axle.…

When selecting the correct replacement axle for a utility trailer you will need to know both the hub face (wheel center) and spring center measurements. For example, if your current hub face measurement is 88" and you replace this with an axle…

Moving the spring seats that far is not recommended for the reason your friend gave as it doesn't carry the weight evenly. My recommendation for you so you don't need to worry about the springs is to use the Timbren Axle-Less System…

It sounds like you are heading in the right direction. To decide where your springs seat will be you will need to mock up your trailer as if you were installing all of the equipment on it. Once you have the suspension part mocked up you will want to…

I do have all of the components you will need to flip the axle on your tent trailer but there is not an all inclusive kit per se to do so. However, the kits are pretty basic as all they include are u-bolts, tie plates, and spring seats. For your…