Do Slipper Spring Rear Hangers Require Bushings
Question:
Is it necessary to use some kind of bushing in these bolt-on brackets for the slipper springs?
asked by: Johnnie D
0
Expert Reply:
Nope, the slipper spring rear hangers like the part # CE14017G do not require the use of a bushing between them and the spring.
I attached a picture that shows how it will look when it is installed.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
CE Smith Rear Hanger Bracket for Trailer Slipper Springs - Galvanized Steel - Bolt On - Qty 1
- Trailer Suspension Parts
- Hangers
- Boat Trailer
- Snowmobile Trailer
- Slipper Springs - 1-3/4 Inch
- 1-3/4 Inch Tall
- Single Axle
- Tandem Axle
- Triple Axle
- CE Smith
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Axle And Leaf Springs For A 4' x 6' Single Axle Trailer
- Q&A: Could Shackle Bolt # 166081 be Used with CE Smith Suspension Hanger # CE14016G
- Article: Slipper Spring Trailer Suspension System Review
- Article: Where to Position the Trailer Axle?
- Q&A: How To Properly Measure Slipper Springs For Your Trailer's Leaf Sping Suspension
- Article: Trailer Wiring Diagrams
- Q&A: Parts Needed For Adding 1,000LB Slipper Springs To a Cart With No Suspension
- Q&A: Can Slipper Spring # e29SR Install Below Trailer Axle
- Q&A: Replacement Slipper Spring Recommendation to Replace 31 inch Long Spring
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Availability of Trailer Replacement Leaf Spring that is 30 inches Long for 1,800 lb Axle
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: How to Measure a Trailer Axle
- Article: How to Accurately Measure Trailer Leaf Springs