Review of Dexter Axle Trailer Axles Parts - Torflex Axle Installation Hardware Kit - DX54FR Video

It is possible to replace your 62" long axle with a longer one. Our next size up is going to be a 72" long 2K rated axle like part #e32GR. The axle being 72" across measured from hub-face to hub-face. This axle comes with 5 on…

The 3 inch shackle bolt part #166081 would be a great option to use with the CE Smith suspension hanger part #CE14016G. This would be a better fitting size than going with the longer 3.5 inch bolt you mentioned.

I completely understand your troubles and confusion with leaf springs. First do remember there are different types of spring steels so the thickness of the leaves is not always the best way to judge the weight capacity for the leaf springs. So while…

As with any manufacturer's recall, the old stock obtained by the vendors will be bought back from the manufacturer and replaced with the new updated version when available. The part number for the product rarely ever changes. I checked with our…

For your horse trailer with Dexter Torflex 3500 lb axles, you will need the Torflex Lift Kit - Tandem Axle - 2-5/8" Lift #K71-707-02 along with two sets of the Dexter Axle Torflex #10 Axle Side-Mount Frame Installation Hardware Kit #DX54FR which…

There isn't anything out there that's going to prevent theft of a Portable Solar System like #34282610. The best you can do is try to make it as hard as possible for a potential thief to steal the panels, but if someone is determined, they…

It could just be the angle but looking at the picture you attached it appears that you have a 1-3/4 inch diameter axle. This would be consistent too with the smaller 2,000 pound axles that are typically on jet ski trailers like what you have. I do…

The BTR and BT8 denotations refer to the spindle, not the trailer hub. The difference between a BTR and BT8 spindle is that the BTR spindle uses a 1.063" diameter L44649 bearing and the BT8 spindle uses a 0.99" diameter L44643 bearing. In…

Yes the slipper spring part #e29SR that you referenced can install below the trailer axle. I attached a picture that shows it installed in this orientation.

Though we have not yet installed the Torflex Lift Kit on a 2014 Lance Lance 1985 Travel Trailer, if you have 3,500 lb Torflex Axles I can confirm that the Torflex Lift Kit part #K71-707-02 will work for you so long as you do not have 3" tall…

I was able to determine that your trailer has torsion axles but not the brand or capacity. We know that Lance likes to use Dexter axles so I would be shocked if it wasn't a Dexter Torflex which the lift kit part #K71-707-02 you referenced would…

The etrailer Axle #e32GR uses a Easy Grease Trailer Idler Hub Assembly #AKIHUB-545-2-EZ-2K which will use the Bearing Kit #BK1-150. I do recommend pulling one of your hubs apart to verify that the bearings and seals match the spindle on your axle.…