etrailer Radius End 4-Leaf Slipper Spring Installation Video

Hey Barrett, ideally you have 2 inches of clearance between the tire sidewall and the frame of the trailer. Where you are at now is going to be not quite enough clearance. We don't have any wheel spacers and honestly 1-1/2 inch wheel spacers…

The closest size we have to a 25.5" slipper spring is 24-5/8". Do understand that this may be the correct size for your application since as leaf springs sag and get flatter they also get longer in length. Also the amount of leaves a spring…

What you need is the Correct Track tandem lift kit part #RR23QX which will give your current suspension setup a lift of up to 2-1/4 inches. Aside from that there isn't a way to gain additional height from the trailer.

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

It can be a flat end as long as the flat part is long enough that it can reach past the wet bolt just fine. For your application it looks like the 4-Leaf Slipper Spring w/ Radius End for 2,000-lb Trailer Axles #e69SR is the closest that we have as…

As long as the 2-Leaf Slipper Spring w/ Radius End for 1,000-lb Trailer Axles - 24-5/8" Long #e36SR is the same length as your current flat-end spring you can use it as a replacement. The only "radius" style of leaf spring that…

You can mount trailer axles above or below the leaf springs. The difference is just the amount of ground clearance that the trailer would end up having. The biggest advantage with the spring below the axle (trailer will be lower) is that you would…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Trailer grease can be pretty thick and might make the hub slightly heavier feeling when turning by hand, but if your hub is difficult to turn by hand you most likely have the spindle nut tightened down too far. When our installers replace a trailer…

I have another option for you, but the #e94SR you were looking at are for 6000lb axles and will be too stiff to use with a 3500lb axle. For the Dexter Trailer Axle w/ Idler Hubs - EZ-Lube - 5 on 4-1/2 Bolt Pattern - 89" Long - 3,500 lbs…

Nope, there is not any type of plastic wear bad to go between the 1-3/4" wide 3-Leaf Slipper Spring w/ Flat End for 2,900-lb Trailer Axles - 30" Long #e49SR and trailer frame.

You are correct, the 5.30x12 is the SAE nomenclature, while the 145/80-12 is the closest metric equivalent. The two are approximately the same size with the 5.3x12 being about a tenth of an inch narrower and a quarter of an inch taller than the…