Tekonsha Brake Controller 3065-P Review Video

I was able to obtain from Curt a chart showing key dimensions for their 3-Piece Trailer Hitch #C15511 (and other hitch models) that I linked for you. This shows that for hitch #C15511 the overall front-to-back length is just under 24-inches. The…

The front two mounting bolt holes are 3 inches apart on the Draw-Tite Ultra Frame Trailer Hitch Receiver #41943, and 16-1/4 inches from the front mounting hole to the furthest. The height is 6 inches as well; this is only a fit for 1999-2021 Ford…

The 2017 GMC Sierra 3500 cab-and-chassis is a confirmed fit for the Draw-Tite Ultra Frame Trailer Hitch #41947 so long as the truck frame width dimension is 34-inches from outside edge to outside edge. This frame dimension requirement applies to all…

Because the mounting flange of the Curt #C15511 Class V hitch has 3 tabs on each side, rather than a continuous mounting flange like many other hitches, it'll fit around the rivet shown in your photo. However, be aware that the Curt #C15511 is a…

I have attached an image of the Draw-Tite Ultra Frame Trailer Hitch Receiver #41947 referenced in your question with a few dimensions labeled. The distance between mounting holes, from the left side mounting bracket to the right side mounting bracket…

The Curt Trailer Hitch Receiver part #13028 could potentially fit your 1966 Chevrolet C10 with aftermarket bumper. However, I would not be able to confirm this as the trailer hitch is only tested with the OEM bumper. I have attached a photo for you…

The Curt Trailer Hitch Receiver part #C15445 which is a fit for a Ford F-Series Cab and Chassis has a drop of 5-1/2" when measuring from the top of the mounting flange or bottom of the frame to the top cross tube. I have attached a photo of this…

I do have an option for you but I cannot recommend you add any spacers in between the trailer hitch and trailer frame as this would affect the integrity of the trailer hitch. Therefore, if the Curt Trailer Hitch Receiver part #13028 does not clear…

I spoke with my contact at Curt and he put together a chart that has all of the dimensions of the hitches you referenced.

The drop of the B & W Class V #BWHDRH25198 is 7-3/8 inches. That represents the distance from the underside of the frame member where the hitch mounts to the top of the receiver tube. If that isn't sufficient to clear your bumper, the Curt…

That's a really good question, and the reason the Curt 3-Piece Trailer Hitch Receiver - Multi Fit #C15511 is able to fit both 34 inch and 37-1/2 inch frames on your 1993 Ford is due to the placement of the side plates. If you take a look of the…

The Curt Trailer Hitch Receiver #C15809 that you referenced will work on your 2012 Dodge Ram 2500 Mega Cab. Cab and chassis model trucks come from the factory without truck beds on them at all. Typically trucks are bought like this so a flat-bed or…