Review of Stromberg Carlson Camper Jack - Trailer Jack - 7145-943-00 Video

Hey Ronald, the landing gear part #RVLG-8HDL does not come with new brackets but we have them available with the part #LG-Brackets. These will need to be welded on as there isn't a way to bolt on the jacks to the brackets you have now.

For starters, the Bulldog Powered-Drive Kit part #BD1824200100 for single speed or part #BD1824180100 for two speed is only designed to work with Bulldog landing gear legs that have a 12,000 lb support capacity. If you do not have these legs than I…

Yes, the Replacement Gearbox for Venture Aluminum Electric 5th Wheel RV Landing Gear Assemblies #LC276602 is the correct replacement gear box for your VMC40RB-091565 gear box.

Essentially the #LG-196308 and the #LC196308 are identical. I'd go with the lower priced of the two since neither is a better choice than the other.

The Dexter Trailer Springs Over-Under Conversion Kit like part #K71-384-00 does not require welding. That said, it is recommended to tack the spring seats to the axle but this is super easy to do even for someone with no prior welding experience.…

The only difference between a 4 leaf spring and a 5 leaf spring like the #e34SR is that the 4 leaf spring will use slightly thicker leaves and is 1/8 of an inch shorter. To get the best measurement of your existing springs, measure the center eye…

I checked with Lippert Components and the Lippert Electric Landing Gear Set #LC333964 and the bolt that comes with the bracket needs to be torqued to 10-18 ft-lbs. You do need to be careful not to get it too tight because you could actually bend…

Ram Landing Gear 12-Volt Motor Kit #LC142178 is rated for use with landing gear having up to an 8000-lb rating, such as set #RVLG-8000. Atwood's discontinued landing gear kit 75721 was rated for 5500-lbs so the new motor will have an easier…

Landing gear legs do typically have weld stop brackets to hold the legs securely to the welded brackets on your trailer frame. The landing gear will have a maximum capacity lift, which for the Replacement Follow Leg for Stromberg Carlson Landing…

The only difference between the #RVLG-8HDL and the #RVLG-8000 is that the #RVLG-8HDL includes the manual crank handle, while the #RVLG-8000 doesn't. The dimensions for both are the same. • Retracted Height of 32-3/4 inches • Extended Height of…

Yes the etrailer Landing Gear Set - 36-1/2" Lift - 8,000 lbs part #RVLG-8000 can be used in the both the older exposed gear applications as well as the newer internal type of applications. I've included the video Jon did on the landing gear…

Trailer landing gear sets like the etrailer.com #RVLG-8HDL that you referenced are designed to bolt onto brackets that are welded to the frame. In terms of function or capacity there is no particular reason you couldn't just weld the legs…