Does the Lippert LC333964 Land Leg Carriage Bolt Have Torque Specs?
Question:
What is the proper torque on the landing leg to bracket carriage bolt nuts on installation?
asked by: Bob V
0
Expert Reply:
I checked with Lippert Components and the Lippert Electric Landing Gear Set # LC333964 and the bolt that comes with the bracket needs to be torqued to 10-18 ft-lbs. You do need to be careful not to get it too tight because you could actually bend the bracket if you aren't careful. The flanges on the bracket # LC113511 should not measure less than 2-3/8" between them (see attached photo).
expert reply by:
Jon G
0
Products Referenced in This Question
Replacement Weld-On 5th Wheel Landing Gear Leg Bracket for Lippert RVs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Brackets
- Lippert
more information >
Product Page this Question was Asked From
Lippert Electric Landing Gear Set - Weld On - 37" Lift - 6,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 5001 - 6000 lbs
- Electric Jack
- Landing Gear
- 37 Inch Lift
- Weld-On
- 2 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: leaf spring
- Q&A: Mounting Brackets to Use with Landing Gear Set # RVLG-8000
- Search Results: over under conversion kit
- Shop: Dexter Trailer Springs Over-Under Conversion Kit
- Shop: Replacement Weld-On Mounting Brackets for Stromberg Carlson Landing Gear - Qty 2
- Video: Dexter Trailer Springs Over-Under Conversion Kit Installation K71-384-00
- Article: How to Raise Your Travel Trailer Height
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Where to Position the Trailer Axle?
- Video: Review of Stromberg Carlson Camper Jack - Trailer Jack - 7145-943-00
- Shop: Dexter Trailer Springs Over-Under Conversion Kit
- Shop: Landing Gear Set w/ Handle - 36-1/2" Lift - 8,000 lbs
- Video: Stromberg Carlson Trailer Jack LG-BRACKETS Review
- Q&A: Does the Dexter Trailer Springs Over-Under Conversion Kit Require Welding
- Q&A: Electric Landing Gear Legs for a 2017 Sundowner 3H GN Super Sport Horse Trailer
- Article: Best Camper Jacks
- Shop: Replacement Weld-On 5th Wheel Landing Gear Leg Bracket for Lippert RVs
- Search Results: dexter springs
- Q&A: Difference Between 5 Leaf and 4 Leaf Spring with Same Capacity
- Shop: Replacement Reduction Box Retainer for Stromberg Carlson Electric Landing Gear Set
- Shop: Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Q&A: Dimensions of I Beam Bracket for Lippert Ground Control Leveling System
- Q&A: Can Fifth Wheel Landing Gear be Installed Externally?
- Q&A: Can Trailer Landing Gear Legs be Welded Directly to Frame
- Search Results: fifth wheel landing gear
- Search Results: rp500708
- Search Results: lc333964
- Search Results: plumbing