Mounting Brackets to Use with Landing Gear Set # RVLG-8000  

For starters, the Bulldog Powered-Drive Kit part #BD1824200100 for single speed or part #BD1824180100 for two speed is only designed to work with Bulldog landing gear legs that have a 12,000 lb support capacity. If you do not have these legs than I…

The only difference between a 4 leaf spring and a 5 leaf spring like the #e34SR is that the 4 leaf spring will use slightly thicker leaves and is 1/8 of an inch shorter. To get the best measurement of your existing springs, measure the center eye…

The Dexter Trailer Springs Over-Under Conversion Kit like part #K71-384-00 does not require welding. That said, it is recommended to tack the spring seats to the axle but this is super easy to do even for someone with no prior welding experience.…

We may have landing gear that works for you, though there isn't any landing gear that will work with space between brackets of 21-1/2 inches, though I'm wondering if maybe you measured from the top of one bracket to the bottom of the…

Yes the etrailer Landing Gear Set - 36-1/2" Lift - 8,000 lbs part #RVLG-8000 can be used in the both the older exposed gear applications as well as the newer internal type of applications. I've included the video Jon did on the…

The Lippert landing gear bracket #LC113511 is 2" long x 3-1/2" wide x 4-1/2" tall just like #LG-Brackets. The top portion of the bracket has a slightly different bend to it, but for all intents and purposes these are…

Ram Landing Gear 12-Volt Motor Kit #LC142178 is rated for use with landing gear having up to an 8000-lb rating, such as set #RVLG-8000. Atwood's discontinued landing gear kit 75721 was rated for 5500-lbs so the new motor will have an easier…

Yes, you can use Replacement Follow Leg for Stromberg Carlson Landing Gear #LG-177201 with your Venture landing gear system. This same leg design is used by many manufacturers so it is interchangeable with them.

Trailer landing gear sets like the etrailer.com #RVLG-8HDL that you referenced are designed to bolt onto brackets that are welded to the frame. In terms of function or capacity there is no particular reason you couldn't just weld the legs…

Your question came in totally blank, all I got were a couple pictures of a drop spindle axle on top of a leaf spring with the U-bolts removed. If you are having difficulty separating the leaf spring from the axle you might try some penetrating lube…

There are nuts on the bolts attached to the spring seats in over/under conversion kit #K71-384-00. The nuts are to adjust the spring seats so that they positioned properly (parallel with original spring seat). And they also transfer road shock/brake…

It is highly recommended that the spring seat be at minimum tack welded to the axle. There have been issues that have resulted from the seat not be welded to the axle. If you do not have access to a welder, I recommend taking the trailer to a local…