Redline Trailer Brakes BRKH12 Review Video

From previous customers with Cardinal 31LE campers the correct brake assembly size you'd need is 12 inch by 2 inch and the set I would recommend is the etrailer part #AKEBRK-7-SA which is a self adjusting set that will work really well and…

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on…

The Dexter Trailer Hub and Drum Assembly #K08-201-9B that you referenced has a stud length of 1-1/4 inches which is the standard length for trailer hubs like yours.

Attached is a photo showing the dimensions of the bolt holes for the Dexter Electric Trailer Brake Kit #23-105-106. The bottom holes are separated by 3" on center while the other bolt holes are separated by 2-1/8" on center. I have…

To get the best braking power for your boat trailer you would want to have disc brakes on both axles. If you happen to be limited to one axle then you would want the rear outfitted. With a 5,000lb boat you likely have two 3,500lb torsion axles. The…

The appropriate torque spec for any application will vary depending on the construction of the wheel as well as on the stud size. I suggest checking the wheels you're using to see if their manufacturer has a suggested torque rating. Steel…

I attached a picture that shows the bolt pattern of the trailer brake assembly part #23-180-181 that you referenced.

The attachment bolts for a 5-bolt brake assembly like the part #AKEBRK-6R should be torqued to 30-50 foot/lbs. If you don't have a torque wrench handy, if you tighten the bolts until the lock washers flatten out, you'll be pretty darn close…

According to Dexter Axle, the attachment bolts for a 12 x 2 brake assembly should be torqued to 25-50 foot/lbs. If you don't have a torque wrench handy, if you tighten the bolts until the lock washers flatten out, you'll be pretty darn close…

You can absolutely use a different brand of bearing, like the 25580 Timken Replacement Trailer Wheel Bearing #TMK44FR, for your trailer. Just make sure the bearing numbers match and you're good to go!

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

Trailer spindles are welded directly to the axle so to remove one it just needs to be cut off completely using a torch or saw. Then to replace the spindle such as with the EZ Lube #TRU37FR that you were looking at it's extremely important that it…