TruRyde Double Lip Grease Seal Review Video

The biggest difference between the servo styles that you'll notice is between free backing plates and the others. The free-backing plates will allow your trailer to back up without having the brakes lock up. With surge brakes typically when you…

The Never Fail Bushings like part #TRBU11566 and the Bronze Bushings like part #D014-077-00 are designed for 1-3/4" wide double eye leaf springs. There is not a version of these which are an upgrade over the factory nylon bushings for 2"…

Hey Kevin thanks for your question. There is not much downside to going with the 5,000 lb springs instead of the 3,500 lb. A higher rated spring may make the ride a bit more "chunky" at times, since the spring would not flex as easily.…

The 4-Leaf Double-Eye Spring for 5,000-lb Trailer Axles #e44SR you're referring to is made in the USA.

Since the D60 Dexter Axle uses a cotter pin and castle nut the #RG05-100 would not be the correct kit for you. For that I would recommend the Trailer Spindle Nut #165686. For a compatible cotter pin I would recommend the Cotter Pin part #165649.…

That will depend on what actuator and brake assemblies you have installed on your trailer. Your best option would be to check out the link I attached that has all of the actuators we carry so that you can identify what you have and then check out the…

Uni servo and duo servo is basically the style of wheel cylinder. It basically puts pressure on either side of the cylinder. The styles are interchangeable so if you have one style over the other you can go with either style. As long as your drum…

It looks like the slipper springs for 7,000 pound axles are 2 inches wide which is good because that is a very common size for slipper springs so there will be options available. We have a 3-5/16 inch long wet bolt in a 9/16 inch, #126B2, but I do…

We currently offer several different spindle washers and I have included a link to them for you. However, none of then have an inner diameter of 1-1/16 inches. I recommend using a set of digital calipers to take the measurement because it needs to be…

The issue is that there is a screw inside the jack that turns in either direct to raise or lower the jack. It threads through a fixed nut. At the very top of the screw the threads are all mashed up so that the leg can't just fall out. Basically…

You'd want the tang washer like the #5-101 that you referenced between the washer and the nut.

You can convert your drop axles to get more height by attaching your leaf springs to the top of the axle. The height you gain will be the thickness of your leaf springs and the diameter of your axle. For example, if your leaf springs are 1-1/2 inches…