Review of Gen-Y Hitch Hitch Pins and Clips - 2.5 Inch Ant-Rattle Hitch Pin - GY99FR Video

It sounds like you might be looking for some hitch fabrication parts and if that's the case we have the Combo Bar with 2-1/2" Trailer Hitch Receiver - Unpainted part #C49511 at 18" which is the longest available. I have attached a full…

The Tuson Towable Tire Pressure Monitoring System part #335TPMS4WIVS will not interfere with factory installed TPMS.

The batteries in the sensors of the Tuson Towable Tire Pressure Monitoring System #335TPMS4WIVS that you mentioned will last around 5 years with normal use and are not replaceable. You'd have to replace the sensor with the part #335TPMS-SENS…

The weight of the Gen-Y Torsion 2-Ball Mount w/ Stacked Receivers - 2-1/2" Hitch - 6" Drop/Rise - 21K #325-GH-1324 is 115 lbs.

Here is a list of the Jensen radio antennas we currently carry. You can compare these with the one on the roof of your 2016 Thor Challenger 37LX to determine if we have an exact replacement or if you will need to remove the antenna from your roof to…

I spoke to my Jensen representative about the Jensen Top/Side Mount Antenna part #44US01R and they informed me that the ground wire coming from the antenna can be attached to either the trailer frame or radio but the trailer frame is the preferred…

It is perfectly safe to use a reducer sleeve like the Curt #C45405 to fit an accessory with a 2" shank into your 2-1/2" trailer hitch receiver. We do have options for you to use a ball mount with a 2-1/2" shank for when you want to tow…

Good question, and the hitch on your Audi is not rated for use with weight distribution, so what I recommend instead is a friction sway control set up. This will provide you with better control over your trailer to give you a much more controlled,…

The B&W Silencer Pad #BWTS35020 is intended to be placed on the shank of one of their Tow & Stow Multi-Ball Mounts like #BWTS10048B so that it acts like a gasket between the collar on the end of the hitch's receiver tube and the…

Some accessories fit more loosely than others in any given trailer hitch. If you think that the receiver is getting worn out, I recommend measuring the inner opening width and height to see if it is still at 2-1/2 inches. Also check the accessories…

The B&W Heavy-Duty Trailer Hitch Receiver - Custom Fit - Class V - 2" #BWHDRH25182 is shown with the factory 245/70-17 tire which has a 30-1/2 inch diameter. The 285/70-17 tire you mentioned is 32.7 inches diameter so it hasn't been…

I went out into our warehouse and grabbed a 2-5/16" Hitch Ball #C40085 to measure and found it is from top to bottom 5-3/4 inches tall.