Gen-Y Torsion 2-Ball Mount Review 325-GH-1324 Video

The weight of the Gen-Y Torsion 2-Ball Mount w/ Stacked Receivers - 2-1/2" Hitch - 6" Drop/Rise - 21K #325-GH-1324 is 115 lbs.

The Gen-Y Torsion 2-Ball Mount w/ Stacked Receivers #325-GH-1324 that you referenced doesn't have the same features as weight distribution or sway control so it's hard to compare them. It will cushion the ride quality when you are…

I do have an option for you but the Timbren Trailer Suspension Enhancement System Light-Duty Trailers part #TTRA1702 is not going to soften your ride. It would most likely do just the opposite of that. The only option we really have for you to soften…

Yes. You can use your existing weight distribution hitch with the Gen-Y Torsion 2 Ball Mount #325-GH-1324 without any additional components, but it is not the optimal setup. Gen-Y recommends that you use the Gen-Y Torsion Weight Distribution Shank -…

The B&W Continuum Weight Distribution System part #BW28FR is great for varying loads since you can easily adjust the tongue weight setting. That said, I don't recommend this system when going off-road as it hangs down too low and could create…

I have attached photos showing the dimensions of the Replacement Sway-Control Bracket #EQ95-01-5600. The larger, L-shaped bracket measures 10 inches long x 2 inches wide and the smaller brackets measure 8-1/4 inches long x 1-1/2 inches wide. These…

Thanks for the picture! The longest weight distribution shank we have that fits a 2-1/2" hitch receiver is the Equal-i-zer Weight Distribution Shank item #EQ94FR. From hitch pin hole to the end of the shank is 12". It has a maximum tongue…

The Curt Rebellion XD like part #C45949-2516 and the Gen-Y Torsion 2-Ball Mount #325-GH-1124 are the two most advanced cushioned ball mounts. As far as cushioning goes the Gen-Y is the winner as it has a design that allows for more cushioning…

Based on the images you sent in it appears your 2005 Starcraft RT10 does not use a traditional A-Frame coupler so the Lock N Roll #336TS504 will not work for your application. Instead you will need to measure the width between your frame rails the…

The Lock N Roll Articulating Coupler #336TS504 dimensions for the A-frame are 2.19" at the narrowest part and 11.22" at the widest part of the opening. It is 9.68" long from largest opening to narrowest. I have included a picture below…

The Lock N Roll Articulating Coupler #336TS504 is listed as a weld-on application because it doesn't have bolt holes and was left unfinished to make the welding job easier. If you were willing to drill holes in the coupler you certainly could…

When it comes to your 10,000 capacity trailer I recommend the Buyers Products Trailer Safety Chains #337B03822SC. They're made out of a zinc-coated steel. They're 22 inches long and the link diameter is 3/8 inches. I attached a review video…