Gen-Y Adjustable 2-Ball Mount with Stacked Receivers Review Video

You absolutely can install air bags on your 2023 Ford F350 SRW Tremor. The Tremor package does have a few tweaks to the rear suspension, but nothing that will effect fitment of air bags. For you I recommend the Firestone Ride-Rite Air Helper…

The mounting holes are 16-1/4 inches apart on the Curt hitch, part #C15845. Also the rivet holes are 3 inches apart. I've included the diagrams of all the mounting hole measurements for you. As well as the install details of the hitch.

For a replacement shock-absorbing adjustable ball mount I recommend the Gen-Y Torsion 2-Ball Mount w/ Stacked Receivers - 2" Hitch - 7-1/2" Drop/Rise - 10,000 lbs #325-GH-1025. The Gen-Y design is incredibly sturdy and will have no…

The Roadmaster Htich Extender #RM-071-1075 measures approximately 3 inches deep from the pin hole to the furthest point inside the receiver tube. It's also only designed to be used to flat tow a vehicle with a hitch style tow bar. It can't be…

We do have a large selection of hitch extenders that will allow for the needed clearance between your tailgate and jack. The shortest extender we have available for 2 inch receivers that has the required capacity for your 8,000 pound trailer is the…

If you are needing to extend the gap between your tow vehicle and trailer, the Roadmaster Anti-Rattle hitch Extender #RM-071-1075 referenced in your question will provide a great solution. This is compatible with any 2 inch hitch receiver and will…

I would be happy to help! The Curt Trailer Hitch Receiver #C15845 you were looking at is designed to fit the 2003 Ford F-350/450/550 Cab and Chassis motorhomes, and will not work on your 2003 Thor Four Winds Hurricane built on the Ford F53 chassis.…

Yes, The Curt Class V Trailer Hitch Receiver part #C15845 will fit all models of the 2019 Ford F-550 Cab and Chassis with 34" wide frames outside to outside.

The weight of the Gen-Y Torsion 2-Ball Mount w/ Stacked Receivers - 2-1/2" Hitch - 6" Drop/Rise - 21K #325-GH-1324 is 115 lbs.

We do recommend backing plates for all e-track installations. They will provide additional support. You will need a set of four backing plates, part #e66RR, for an 8' section of E-Track. I have included a product description link, a weblink on…

You are correct, the Replacement Footpad Kit #LC86UD is mounted with the bolt, flat washer, o-ring, footpad and finally the 2nd o-ring before threading into the base of the hydraulic jack.

The Gen-Y Torsion 2-Ball Mount #325-GH-1824 that you referenced does now come with set screws on the sides of the square openings to allow the movement of the ball and retainer to be reduced. I attached a picture of them for you to check out. The…