Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"

See what our Experts say about this CURT Trailer Hitch

• 3 Bike Rack Recommendation for a 1998 Buick Regal GS with Rear Spoiler
  We do have an option for carrying 3 bikes on your 1998 Regal GS with a rear trunk spoiler, but Thule states that the 1997 to 2004 Buick Regal cannot support the weight of their trunk mount bike carriers, and Yakima has not had the opportunity to test these vehicles with a rear mounted spoiler. I would recommend going with the Curt Class II Trailer Hitch, item # C12225, on your vehicle and then using the Swagman Trailhead 3 Bike Carrier, item # S63365, for carrying 3 bikes. An upside to...
  view full answer...
• What are the Weight Capacities of Curt Trailer Hitch # C12225 for a 2003 Pontiac Grand Prix
  The Curt Trailer Hitch, # C12225, has a tongue weight capacity of 350 pounds and a gross trailer weight capacity of 3,5000 pounds. This is a Class I hitch with a 1-1/4 inch receiver opening. I have included a link to the instructions for this hitch below. You may also be interested in the 4-Pole Hardwire Kit Including Circuit Tester, # 18252, which will provide you will a 4-flat trailer connector at the rear of your vehicle.
  view full answer...
• Which Vehicles Will the Curt Class II Trailer Hitch Receiver Hitch, # C12225 Fit
  The Curt Class II Trailer Hitch Receiver Hitch, # C12225, will fit the following vehicles: 1997 - 2008 Pontiac Grand Prix GT Coupe and Sedan 1997 - 2004 Buick Regal I attached the installation instructions for your reference.
  view full answer...
• Hitch Recommendation for Carrying 2 Bikes Using Thule T2 Classic # TH9044 on 2005 Pontiac Grand Prix
  I have another option for you. You'll want to use the Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4" # C12225. Due to the higher 300 lb tongue weight capacity of this hitch, which is lowered to 150 lbs by the # HTAD adapter, you could use your Thule # TH9044 rack and still have a little capacity remaining. The problem you're going to run into using a Class I hitch along with the adapter is that the tongue weight capacity of the hitch will be reduced by 50 percent. The rack...
  view full answer...
• Trailer Hitch and 2 Bike Rack Recommendations for a 2003 Pontiac Grand Prix SE
  For your 2003 Pontiac Grand Prix, there are two Class II hitches available. We have the Draw-Tite Trailer Hitch, # 36241 and the Curt Trailer Hitch # C12225. They both are class II, have a tongue weight capacity of 350 pounds, have a towing capacity of 3500 pounds, and have a 1-1/4 inch hitch opening. They both do not require drilling for installation and need the exhaust to to be temporarily lowered for installation. The Draw-Tite # 36241 is expected to be easier to install than...
  view full answer...
• Trailer Hitch Recommendation for a 2004 Buick Regal
  I think you meant to type 2004 Buick Regal since there was no 2006 Regal. For a hitch to fit a 2004 Regal you would want the Curt part # C12225 which has been confirmed as a fit. For a ball mount you would need part # 36065, for a 1-7/8 inch ball part # 19256, and for a 2 inch ball part # 19258. For trailer wiring part # 18252. Cost is available at the product links.
  view full answer...
• Is Mounting Hardware Available for the Curt Hitch # C12225
  Yes, we have a replacement hardware kit for your hitch. You can use item # RHK in the search box and then put in the hitch part # C12225. When this is complete add the item to your cart, checkout and you will receive the correct installation hardware for your hitch.
  view full answer...
• Is the CurtTrailer Hitch, # C12225 Class I or Class II
  The CurtTrailer Hitch Receiver Hitch, # C12225, for the 2008 Pontiac Grand Prix is actually a class II hitch so it will not have the protrusion that will prohibit Class II devices. The protusion that you have heard about is on the Class I hitches since they can be easily overloaded when using a Class II device. So that protrusion is there as a safety precaution. This will not be a problem for you since this Curt hitch is a class II.
  view full answer...
• Does the Curt Hitch for a 2004 Pontiac Grand Prix Come with Hardware
  The Curt Trailer Hitch Receiver part # C12225 which is a fit for a 2004 Pontiac Grand Prix does come with installation hardware. The installation hardware is as follows: QTY: 2 - 1/2-13 HANDLE NUT QTY: 4 - FW12 FW, 12, ZP QTY: 2 1/2-13 x 1 1/4 HEX BOLT QTY: 2 1/2" LOCK WASHER QTY: 4 CM-SP1 .250 x 1.50 x 2.00" SQUARE HOLE SPACER QTY: 4 1/2-13 x 1 1/4 CARRIAGE BOLT QTY: 4 HFN 1213 HEX FLANGE NUT
  view full answer...
• Trailer Hitch for 2008 Pontiac Grand Prix for Scooter Carrier
  The highest capacity hitch we have for your 2008 Pontiac Grand Prix is going to be the Curt part # C12225 which has a tongue weight rating of 350 lbs. You would need to make sure the weight of your carrier and scooter weighs less than that together.
  view full answer...
• Will the Curt Class II Trailer Hitch # C12225 Fit a 2012 Ford Fusion
  I have a hitch solution for your vehicle, but the Curt Class II Trailer Hitch, # C12225, will not fit your 2012 Ford Fusion. Instead, you will want to get the Draw-Tite Sportframe Class I Trailer Hitch, # 24865. We have installed this trailer hitch on a 2012 Ford Fusion so I linked the video and installation instructions for you to check out. If you are looking to do some light towing with your vehicle, then you will also want the T-One Wiring Harness, # 118422, ball mount, # 3594, 1-7/8...
  view full answer...
• Will Curt Class II Hitch # C12225 Fit 2006 Pontiac Grand Prix GXP
  For your 2006 Pontiac Grand Prix, I recommend the Draw-Tite Class II Frame Receiver Hitch # 36241. I checked with Draw-Tite and this Class II hitch is confirmed to fit all models of the 2006 Grand Prix. I have attached the complete written instructions for your reference. This is a really nice hitch that will provide you with a 1-1/4 inch receiver to use for hitch-mounted accessories or some light towing. If you can tell me what you plan on using the hitch for (bike/cargo rack, towing...
  view full answer...
• How to Order Replacement Hitch Hardware for Curt Hitch C12225
  The part number you will need to order replacement hardware for the hitch part # c12225 is part # RHK. On its product page you will need to enter the part number of the hitch and purchase the kit and we will ship you out a complete set of the correct hardware to reinstall this hitch.
  view full answer...
• Hitch for the 2004 Pontiac Gran Prix GTP
  Trailer hitches are divided into Classes by weight carrying and tongue weight capacity. Class I hitches normally, not in all instances, have a 2000 pound towing capacity and Class II hitches normally, not in all cases, have a 3500 pound towing capacity and a 300 to 350 pound tongue weight capacity. For your Grand Prix we have a Class II hitch, the Curt, item # C12225, that will allow you to select bike racks and towing products. We have help article (see link) that explains hitch classes...
  view full answer...
• Trailer Hitch Recommendation for a 1999 Pontiac Grand Prix GT Coupe
  We do have trailer hitches that are specifically designed to fit the GT model of the 1999 Pontiac Grand Prix. You can use the Curt # C12225. I have included a link to the installation details for reference. If you plan on doing some towing, the recommended ball mount is # 36065 for use in the rise position only. For a pin and clip, use # PC2. For a ball, you can use # 19256 (1-7/8 inch diameter) or # 16258 (2 inch diameter). For trailer wiring, you can use 4-Pole Hardwire Kit Including...
  view full answer...
• Trailer Hitch Recommendation for a 2001 Buick Century
  For your 2001 Buick Century you would need a Draw Tite Trailer Hitch for the Buick Century, part # 36374. I attached installation instructions and an instructional video for this product below for you to check out. The Curt Trailer Hitch Receiver, part # C12225, that was on your Buick Regal would not work on your Buick Century. If the hitch is still in good shape, you might be able to find someone else with a 1997-2004 Buick Regal or a 1997-2008 Pontiac Grand Prix GT, Coupe and Sedan...
  view full answer...
• Will the Draw-Tite Hitch Part # C12225 Scrape on a 2007 Pontiac Grand Prix
  Whenever you install a trailer hitch receiver like the Curt Trailer Hitch Receiver part # C12225 on a vehicle that sits low like your 2007 Pontiac Grand Prix, the chance of scraping is always going to be a concern. However, what you can do is have a skid wheel like part # UF48-979022 welded to the bottom of the receiver tube as this would then prevent any scraping. This is the only option we have to prevent scraping. If you can tell me what you will be using the trailer hitch for, I would...
  view full answer...
• Trailer Hitch Options for a 2004 Buick Regal
  We do offer the Curt Class II Hitch, part # C12225 trailer hitch for your 2004 Buick Regal. This hitch comes with a tongue weight capacity of 350 lbs and a gross towing weight capacity of 3500 lbs. These weight ratings can also be limited by the tongue weight and towing weight capacity of your vehicle. In the event you are wanting to tow a small trailer you will need a few more items. You will want a pin and clip, part # PC2, and a wiring harness, part # 18252. We offer different sized...
  view full answer...
• Installation of Curt Trailer Hitch on 2001 Buick Regal
  While there is no installation video of Curt Trailer Hitch # C12225 on a 2001 Buick Regal, we have attached the installation instructions. This hitch is rated 5 out of 10 for difficulty. Ther is some drilling required and you must temporarily lower the exhaust during installation. It is noted that a bolt leader would make this install and easier task.
  view full answer...
• Could a 2004 Pontiac Grand Prix Tow a Wave Runner with a Trailer Hitch
  That depends on the weight of your wave runner and trailer. The Curt Hitch part # C12225 that your referenced is a Class II hitch with 3,500 lbs towing and 350 tongue weight capacity. If your trailer falls under those figures, then yes, this hitch would work for you. You will need to also check your owner's manual to determine what your vehicle's towing capacity is as hitches for vehicles do not always have the same capacities. The lower figure of the two would be your overall towing...
  view full answer...
• Can I Tow an ATV with 2006 Pontiac Grand Prix with Curt Trailer Hitch
  The Curt Class II Trailer Hitch Receiver, part # C12225, that you referenced is a confirmed fit for your 2006 Pontiac Grand Prix. This trailer hitch has capacities of 3,500 lbs gross trailer weight and 350 lbs tongue weight. You will need to add the weight of the ATV trailer with the weight of your 2014 Yamaha Grizzly and make sure you stay under the weight limit of trailer hitch. Additionally, you should consult the owner's manual of your Grand Prix to determine what Pontiac recommended...
  view full answer...
• Determining Which Bike Racks Are Compatible with Recessed Curt Hitch C12225 on 1998 Buick Regal
  The Curt Trailer Hitch Receiver # C12225 referenced in your question is confirmed to fit your 1998 Buick Regal but the receiver portion will sit pretty recessed behind the rear bumper. This means when picking out a bike rack it is important to note the bumper clearance dimension for the particular rack you are looking at. This is indicated by the distance from the hitch pin hole on the shank to the closest part of the bike rack. If you already have the hitch installed I recommend taking...
  view full answer...
• Ground Clearance on Curt C12225
  We had the opportunity to test fit hitches on the Pontiac Grand Prix and found that the Curt Hitch # C12225 has just 7 1/2 inches of clearance from the bottom of the receiver to the ground. The Curt Hitch # C12225 has a nice powder coat finish that tends to hold up better than that used by other brands, so the hitch will better fight rust and scratches. For the installation, it will be helpful to have a nylon tube brush like # 814092 and some spray lubricant for cleaning out the weld...
  view full answer...
• What Is Needed To Tow A Pop-Up Camper With A 2004 Pontiac Grand Prix GT1
  Yes, you can tow a small pop-up camper with your 2004 Pontiac Grand Prix GT1, as long as the camper does not weigh more than 3,500 lbs. loaded. But, you will always want to check the owners manual or with the dealer for the gross towing weight capacity of your 2004 Pontiac Grand Prix GT1 to make sure the towing capacity is not exceeded. The Curt 1-1/4 Inch Class II Hitch, # C12225, would be a recommended hitch for your vehicle. It is a Class II hitch which has a 3,500 lbs. towing weight...
  view full answer...

Do you have a question about this Trailer Hitch?