Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
This 12-volt motor replaces the one that came standard on your single, double, or triple electric Lippert Coach Step sliding step. It installs underneath the main unit and attaches to the gear assembly.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today, we're going to be taking a look at the replacement motor for an electric coach step. This replaces the 12 volt motor that came standard on your single, double, or triple electric Lippert coach step or Stromberg Carlson sliding step. This unit's designed to power the gear assembly that allows the step to extend and retract. It draws power directly from the RV battery which is going to allow it to bypass the electrical system. It simply installs underneath the base of your step with three bolts. Here's the mounting location for those bolts.
Those bolts are not included. The motor in the gear box assembly can be replaced by disconnecting the two pin connector from the module to the motor and then you'll need to remove the p clamp. That's going to be holding the harness to the motor mount. You'll also need to remove the ball joint linkage from the gear and remove a self tapping screw that holds the ground wire in place. Then you'll need to remove the three bolts that hold the motor mount to the step base. I do want to mention that care should be taken not to disturb the adjustment in the length of the ball joint linkage.
Then you simply install the new motor in reverse order. Really simple process. Only takes a few minutes to do. I do need to mention that you need to know that no adjustment is required. You will notice that this is a weather proof plug. It's got the snap lock designs once it's connected, snap lock together, and then it's got the jacketing that goes over the wires.
It's going to keep those safe and protected. That's going to do it for today's look at the replacement motor for an electric coach step. Again, this replaces the 12 volt motor that came standard on your single, double or triple electric Lippert coach step or Stromberg Carlson sliding step.
Average Customer Rating: 4.7 out of 5 stars (138 Customer Reviews)
This 12-volt motor replaces the one that came standard on your single, double, or triple electric Lippert Coach Step sliding step. It installs underneath the main unit and attaches to the gear assembly.
After a year the drive motor us still working fine. Original installation was fairly easy, except the mounting holes did not exactly line up. I had to enlarge one of them in order to get it to align.
The product arrived in good time and was the exact part I had ordered. It was manufactured by the same as the orginal. It took me about an hour to replace after I had the old one out. Depending how mechanical you are it may take less or more. I have work as a maintnence man for years but this was simple. I advise if you do it yourself watch for the spacer for the motor that you don't lose any. One goes on each side of the motor. The allen on the the fixed gear on the frame has to be loosen to take off the old and to replace the new. Thank etrailer.com your product and price was great. I hope not to have to repair anything else but will be sure to check with you for parts. Thanks Again.
Dennis Z.
6/27/2014
Still working good. Thanks
Did not bold right in place,had to drill out 3 mounting bolts holes
Jenny N.
9/5/2023
We have had similar reviews on this replacement motor. I have reached out to the manufacturer and as soon as they can give me more information I will contact you.
Jenny N.
9/20/2023
I finally did hear back from Lippert. They advised that sometimes holes do need to be drilled out to make this fit. It is the only motor from this brand of steps for this Coach.
Motor and Bolt pattern were correct.
Had to drill out the holes. My RV had 6mm bolts and the motor holes appeared to be for 5mm clearance. Had to clamp the motor in a vice so it wouldn’t get away from me.
Note to others, pay attention to the linkage orientation before disconnecting. Take a picture before.
Steps are working very smoothly now.
I was not pleased to find that the bolt holes had to be drilled out to 1/4" in order to use the original bolts that had to be reused.
Other than that, it fit and worked perfectly.
While traveling, my motor coach steps motor failed. I found the part on Amazon.
I decided to call etrailer anyway because I have dealt with them in the past and found their customer service to be first rate. I am very happy for that decision.
etrailer, price matched Amazon. No big deal there. However, the part did not arrive as expected. I tracked it via UPS tracking and it showed the part as delivered. It was delivered, to the wrong house! I am quickly running out of time and UPS is not answering the phone. Out of desperation I called etrailer at 8:00 PM and Tammie answered! After business hours Tammie contacted UPS via their contact information. Within a few minutes the UPS supervisor and driver had contacted me.
It was determined that the part got dropped off at the wrong address. etrailer immediately sent out a replacement part and settled up with UPS on their end.
What service.
Part arrived and all is well.
I would definitely order from them again.
Warner
11/8/2020
Still working fine.
I purchased a replacement motor for a Lippert Electric Coach Step (part # 301695) could not complete the installation because the part had a manufacturing defect in that the original bolts would not fit into the motor's bolt holes because the bolt holes were too small. etrailer has recieved complaints of this same issue since at least January 2021 and yet they still choose to sell and send a defective part to me. I was given the option to return the item for a refund... however I took a risk and drilled out the bolt holes on the motor with a 1/4" drill bit and then was able to complete the installation. The motor worked just fine and my steps are working properly.
Kirby
4/17/2022
Steps are working great!
The primary gear on the Kwiki power step needed replacing. The original motor was still operating.but it was noisy. After 13 years of use it needed replacing. The new motor was installed but was defective. A second motor was sent by etrailer and it has been operating perfectly. Etrailer replaced the defective motor without any questions.
Dwight L.
9/26/2020
The motor is working fine with out any problems. etrailer has be great to work with in obtain other items when needed.
I received the replacement motor for my Lippert electric coach step LC301695 exactly on the day promised, was able to install it in about 1/2 hr and it worked beautifully!
Execellent service , thank you
Robert R.
7/7/2019
Flawless! I am very pleased with the purchase
The motor looked identical but the mounting bolt holes were in the wrong place to mount to my Newmar RV. etrailer was excellent in accepting the return and providing me a credit. Have not ordered a replacement yet.
Step motor worked perfectly! Steps didnt work that good when the MH was new ! Although under warranty back then, all they would do is grease the pivot points and blame it on the chinese!
Best part of this venture was dealing with Barb at Lippert and another parts man, who guided me to the correct motor , and putting me through to etrailer where Geoff also confirmed what I needed, and shipped it immediately.
I dont have a picture to share, but, instead of the steps ,when retracted, staying up, would jiggle down about half way. Now they quietly retract and stay up. I'm keeping both Lippert and etrailers phone # on speed dial. Thanks folks
Nova Scotia
Canada
2005 Newmar Kountry Star
It was a great fit just what I needed to fix my steps on my motorhome .looks to be a good replacement. Thanks for the quick shipping.
Douglas L.
6/18/2020
Still working great Thanks
~ One year ago, I received the replacement motor for my Lippert Electric Coach Step. The motor that I received was correct. I installed the motor on my Tiffin Class A Breeze electric step, and it has worked fine since then. No complaints.
I had trouble finding the replacement motor for my electric steps on my 1996 Southwind. They are Kwikee Step series 32, I was told that Kwikee no longer made the motor. But the Stromberg Carlson motor SP 1636669 was the direct replacement. It took less than an hour to do the job.
grrrrrrreat service. got the rig;ht part and ;was able to have it sent next day air. had it before lunch the next day..
Emily was very knowledgeable and helpful. This was my first dealing with etrailer and I will definitely use them again when I need a part.
Marshall F.
9/1/2020
Its still working great
I’ve used etrailer several time and I’ve always been extremely pleased
I purchased this electric step rv motor thru e trailer for about 30 percent less than any place else!??. They shipped it to me in two days , as camping world told me it would be two weeks to get it !!! Quality products & great service !????
I purchased this motor from etrailer, with their price match pledge. They were great to deal with, as always, and the product arrived quickly and works great.
REPLACEMENT NOTE: I replaced the original step motor, (#300-1406) on my Lippert Double Coach Step, (#128980) with this new step motor, (#LC301695). Per Lippert, this is the correct motor, however, I had to ream out the 3 mounting holes as the original mounting bolts would not fit through the slighter smaller holes in the new casting. Not a big deal, but know this ahead of time so you are prepared with a drill/bits to complete the job.
I have recently purchased a tow bar and a electric motor for the power steps on my motorhome and have been extremely happy with both products. Very quick turnaround of product when ordered and better price than most competitors online.Free shipping was also a bonus!! Will definitely look here first when I need something else.
This was a direct replacement for my Newmar Kountry Star 2007 with two steps. The old motor no longer held the steps in place. The new motor arrived as promised and like others, I had to drill out the holes to be large enough to hold the old bolts. After doing that, it was just a matter of bolting it up all back up with the spacers in their proper positions. Connected the electric (new plug worked with old connector) and first test showed everything worked as expected. My steps work like new, actually a bit faster than the older motor, so very pleased with end result.
The motor runs fine, but the bolt holes were too small diameter for the OEM bolts. I had to drill the holes to a larger diameter. The hole alignment was also not correct to match the original pattern. Drilling the holes larger gave enough tolerance to align the motor to tighten down. I hope I did not buy Chinese junk.
Sierra K.
9/27/2021
This is a universal product for Lippert Coach electric sliding steps. So it is a general fix to all the single, double, or triple Lippert Steps. For that reason, some modification may be needed.
Great customer service. I've ordered parts from etrailer before and they're always very helpful. Lindy originally helped me with the order and it was shipped right on time. I had to call back with a question and Nichole was very eager to assist. Only issue I had was the holes in the motor for the mounting bolts were to small. I had to drill them out a little but then installed easily. Worked better than the original part.
My name is Mario, just wanted to let you know the electric motor for the electric steps on my rv arrived on time and I just finished installing it. Everything is now working normal again.
Thank you for an outstanding customer service experience.
I would recommend your products and service .
Very satisfied with the ordering process. The web site provided detailed pictures and clear information concerning the step motor I ordered. I finally got to put it on and it works great. Hopefully it will continue to work and I would recommend etrailer based on my experience and look forward to using the web site for future items for my motor home.
I had to drill out the mounting holes to use the original bolts to mount the motor to the original holes. When I was done and checked the operation it ran great and was very quiet.
Robert
3/14/2022
Very well.It is very quite.
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Les
3/3/2024
Still working great. No issues at all. Definitely recommend as a replacement for the OEM stair motor.