etrailer Trailer Hitch Receiver Adapter And Extender Review e43YR Video

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I would discourage the use of an adapter for use of 2 inch accessories in 1-1/4 inch trailer hitch receivers. The reason is that the adapter places the carrier farther away from the rear of the vehicle and hitch, creating additional torque that 1-1/4…

The dimension you are looking for is 4-3/4 inches.

When you use a hitch adapter like the part #HTAD you cut the capacity of the hitch in half. The bike rack would not be affected, but the hitch and frame of the vehicle where the hitch attaches would potentially be affected if you were to overload the…

The Brophy part #HTAD is going to be the best solution we have. This is 7-1/4 inches long and is Class I hitch compatible. You should note that these adapters cut the capacity of the hitch they are installed in by 50 percent. I attached a review…

The Hitch Adapter 1-1/4 inch to 2 inch Trailer Hitch Receiver (Class II Only), item #80303, will not slide into a Class I receiver far enough for the hitch pin hole to line up with the hitch pin hole in the Class I hitch. The Class I hitch is…

You are experiencing a common dilemma. The use of any adapter does decrease the hitch tongue weight capacity by 50%. If your MKX Class II hitch offers a 350 lbs tongue weight capacity then with an adapter the bikes and rack combined cannot exceed 175…

We offer ball mounts that fit 1-1/4 inch hitches that are compatible with 2 inch hitch balls. For example we have the #3593 which fits that hitch size and then for a 2 inch hitch ball we have the #19258.

I definitely have some options so that you can use your Yakima Hold-Up EVO Bike rack #Y02480, but the reason Yakima does not recommend using an adapter with this bike rack is because most hitch adapters reduce the weight capacity of your hitch by…

The only 2 bike add-on that's compatible with the Yakima HoldUp part #Y02479 that you referenced is the EVO add-on part #Y02482. The previous model Holdup is not compatible with the EVO version.

The Roadmaster High-Low Adapter for Tow Bars #RM-076 that you referenced would be perfectly for what you need. It will give you the 6 inches of drop and will also extend the ball mount out an additional 10-1/4 inches.

We carry one 2 inch trailer hitch receiver to fit your 2015 Subaru Impreza, the EcoHitch, part #306-X7211. However, it only fits if your vehicle has the knock out panel on the rear bumper. If your Impreza doesn't have a knock out panel then…