Brophy Hitch Adapters - Hitch Expander - HTAD Review Video

We do have an adapter that will allow you to attach a 2" cargo carrier to the 1-1/4" hitch on your 2016 Nissan Altima. I recommend the adapter #e43YR. This is 6-1/2" long and will go in to your 1-1/4" hitch and give you a 2"…

To wire two 6-volt batteries in series to produce 12-volts, you would connect the load to the positive terminal of battery #1. Connect the negative terminal of battery #1 to the positive terminal of battery #2. Ground the negative terminal of battery…

The Swagman Current Bike Rack part #S64678 that you referenced is designed to fit a 1-1/4 inch hitch or a 2 inch hitch. If you have a sleeve adapter for your 2-1/2 inch hitch to reduce it down to a 2 inch hitch this rack would work great. I attached…

I reached out to Swagman who verified you are still able to use the Loading Ramp #S59SR with your Escapee Bike Rack #S39SR. They mentioned you will have a bit of a hump to get over when going from the rear wheel carrier to the front wheel carrier.

The Brophy part #HTAD is going to be the best solution we have. This is 7-1/4 inches long and is Class I hitch compatible. You should note that these adapters cut the capacity of the hitch they are installed in by 50 percent. I attached a review…

We offer ball mounts that fit 1-1/4 inch hitches that are compatible with 2 inch hitch balls. For example we have the #3593 which fits that hitch size and then for a 2 inch hitch ball we have the #19258.

When you use a hitch adapter like the part #HTAD you cut the capacity of the hitch in half. The bike rack would not be affected, but the hitch and frame of the vehicle where the hitch attaches would potentially be affected if you were to overload the…

The length of the lower bar, pin hole to pin hole, is 10 inches.

The Roadmaster High-Low Adapter for Tow Bars #RM-076 that you referenced would be perfectly for what you need. It will give you the 6 inches of drop and will also extend the ball mount out an additional 10-1/4 inches.

The distance from the back of the 2 inch hitch opening of the Brophy Hitch adapter part #HT5R back to the center of the hitch pin hole on the 1-1/4 inch shank is 3-3/8. I attached a picture where that dimension has been added as well.

I do have an option for you, however the EcoHitch Stealth Trailer Hitch Receiver #306-X7261 referenced in your question is only designed to fit the 2010 Subaru Impreza 5-Door Wagon with the quad exhaust. It will not fit your Impreza if it features…

What you described is one of the downsides of using a hitch extender like the #HTAD. It adds a bunch of movement to the hitch. If the bike rack has a standard hollow shank with a non-threaded hitch pin you could use the part #63232 for that portion…