Roadmaster Quiet Hitch Immobilizer Review Video

Yes, with the Kuat Pivoting assembly part #PVD20B swung out all the way you would be able to fully swing open the rear door of your Sprinter. We had a customer with a similar Sprinter send us a picture where you can see that it would give the…

I was able to get an updated version of the installation instructions of the Curt Trailer hitch part #C11402 for the 2016 Hyundai Sonata with under body panel. The the 2-3/4" X 5-1/2" square is cut out between the tabs on the panel like in…

When we installed the Curt hitch #C11402 on a similar 2018 Hyundai Sonata to your 2019 model we found that from the top of the hitch down to the ground measured 10-1/2 inches. Since Class 3 hitches are only available for higher capacity vehicles that…

The curve in the Malone Anti-Rattle HitchLock System part #MPG908 is designed for extra stability to not allow the shank of the accessory to move up and down. It is what holds the shank of accessory tight. I have attached a photo of how this is…

When you use a hitch adapter like the part #HTAD you cut the capacity of the hitch in half. The bike rack would not be affected, but the hitch and frame of the vehicle where the hitch attaches would potentially be affected if you were to overload the…

You are correct and the upper arms are narrower than the basket at the bottom of the Viking Solutions Carrier part #310-VSR201. The top one is going to have an inside dimension of 29-1/2 inches long, by 14-3/4 inches wide. The bottom basket is going…

The Hitch Adapter 1-1/4 inch to 2 inch Trailer Hitch Receiver (Class II Only), item #80303, will not slide into a Class I receiver far enough for the hitch pin hole to line up with the hitch pin hole in the Class I hitch. The Class I hitch is…

What you described is one of the downsides of using a hitch extender like the #HTAD. It adds a bunch of movement to the hitch. If the bike rack has a standard hollow shank with a non-threaded hitch pin you could use the part #63232 for that portion…

You are experiencing a common dilemma. The use of any adapter does decrease the hitch tongue weight capacity by 50%. If your MKX Class II hitch offers a 350 lbs tongue weight capacity then with an adapter the bikes and rack combined cannot exceed 175…

We offer ball mounts that fit 1-1/4 inch hitches that are compatible with 2 inch hitch balls. For example we have the #3593 which fits that hitch size and then for a 2 inch hitch ball we have the #19258.

The Brophy part #HTAD is going to be the best solution we have. This is 7-1/4 inches long and is Class I hitch compatible. You should note that these adapters cut the capacity of the hitch they are installed in by 50 percent. I attached a review…

We have 1-1/4 inch hitches that fit your 2013 Nissan Altima like the #24796 but the 2 inch hitch size is reserved for the higher capacity vehicles like trucks and SUVs which is why we don't offer this size for your vehicle.