Demco Hydraulic Brake Line Kit for Trailers Review Video

The Hydraulic Line Kit #9579-01 comes with two 18" flex hoses and two 51" steel lines.

For a brake line kit to add a brake axle to an existing setup you'd just need the part #9579-01. This is listed as a 3rd axle kit but in reality it's the same thing as adding a second axle.

Yes, the brake pads that come with the DeeMax disc brake kit part #DE22FR are stainless steel backed. For replacements you'd want the part #DE98VR.

What a lockout on a hydraulic brake coupler does is prevent the brakes from applying when you back the trailer. An electric lock out is tied into the reverse lamp circuit on the vehicle so that when the vehicle is shifted into reverse the solenoid in…

Yes we actually installed the Torsion Demco Brake Line Kit part #DM5425 on a leaf spring trailer like what you asked about. You can see how we did it in the attach picture. I attached an install video for this for you to check out as well.

You wouldn't need a triple axle brake line kit, #HS496-253, because the Titan Disc Brake Kit #T4843800 already comes with 2/3 of what you need. So you would need a single axle kit #DM5424 or #DM5425.

If you shortened the lines of the Demco Hydraulic Brake Line Kit for Single Torsion Axle Trailers #DM5424 you'd have to have the ends of the line flared so what most do is coil the excess line with a tube bender. This also adds some flexibility…

The Kodiak Disc Brake Kit - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs #K2HR35DKG will work fine on the second axle of your 2013 Venture boat trailer as long as the bearings and seal inner diameters match your spindles. This kit has the…

According to Demco, you will want to fill the brake fluid reservoir 3/4 of the way full with new DOT 3 or DOT 4 brake fluid. If you are bleeding the brakes, you will want to check the brake fluid level to ensure that it remains above half full during…

The reverse lockout solenoid wiring of your #DM62VR is not polarity specific. This means that you can use either as the power wire or the ground from your reverse light circuit. As long as one has power and the other ground you are good.

The Dexter DX7.5L A-60 Brake Actuator w Electric Lockout #DX56FR is designed to mount on a 3" x 5" straight tongue. In order to make this work for your trailer, you would need to use a flexible brake line since the actuator and line will be…

The attachment bolts for a 5-bolt brake assembly like the part #AKEBRK-6R should be torqued to 30-50 foot/lbs. If you don't have a torque wrench handy, if you tighten the bolts until the lock washers flatten out, you'll be pretty darn close…