Brophy Trailer D-Ring Tie Down Review Video

The best option is actually going to be to raise the back of the trailer to compensate for the height at the front. There are a couple of ways to do this. First, if the trailer uses double-eye leaf springs AND the axles are on top of the leaf spring…

Yes, we have the Buyers Products Water Cooler Holder, #3375201005. For propane we do not currently have something of this style of holder. .

To confirm if you will be able to go to a larger off-road wheel and tire size there are a few things you will need to do first, as the Westlake ST235/75R15 Off-Road Tire w/ 15" Liger Aluminum Wheel #LH46FR will not fit. Your 2020 Forest River…

That is correct, you can tap into the plug and it will provide a charge but keep in mind that this is not the most efficient way for charging a battery. This method does not provide any charge balancing or battery charge management and on newer…

The Brophy Camper Scissor Steps part #SS03 weigh 27 lbs total.

The Brophy Camper Scissor Steps for truck campers, #AS04, are intended for an entry height of 31" to 40". If your camper door sets within that 31-40' range then yes this will fit your rig. Please see attached image for measuring points…

The HSSF hold down brackets would use the Tie Down Hardware Package, part #TDHP, which includes hooks, chain and turnbuckles. The tie down hardware would typically attach to existing eye bolts built into the underside of camper. If your camper does…

The Aluminum Scissor Steps #AS03 that you referenced weigh 15 lbs and the Scissor Steps #SS03 weigh 29 lbs. As you can see, aluminum is much lighter.

If you check out the install picture I attached for the #AS23 you can see where it normally installs at the rear of a camper that is installed on a truck. Without seeing your setup it's hard to be more specific but there should be a spot on the…

The GearSpace 34 cargo carrier will work for you, but as for opening the rear doors you will need to verify with some measurements. It should based on customer feedback, but we haven't test fit it ourselves; I did add a cut out of a review a…

I attached a picture that shows what type of lighting requirements are needed for a trailer over 80 inches in width as well as a link down below that covers this as well.

Yes, if you check out the picture I attached you can see the GearSpace Carrier part #HGK826 installed in the hitch of a Roadtrek RV built on a Mercedes Sprinter chassis and the door was able to open with the carrier slid out.