BoatBuckle Pro Series Kwik-Lok Bow Tie-Down Strap Review Video

We carry exactly what you are looking for, the BoatBuckle Pro Series Kwik-Lok Bow Tie-Down Strap #IMF18741. The hook end of this strap attaches to your boat's bow while the loop on the other end goes around your boat trailer's frame.…

I would just check to make sure at the start of installing the BoatBuckle Pro Series Kwik-Lok Bow Tie-Down Strap #IMF18741 that you have ran the looped end of your strap from behind the buckle under the boat frame. Once that looped end is brought…

For a similar 2 inch wide PWC winch strap that does come with a nut and bolt for attaching to a winch you would want the part #FWS200200. I attached a review video for you to check out for more info as well.

Yes if you used a self-tapping screw like the part #FA1131822 you could use it to ground trailer wiring to a frame. Sometimes aluminum trailer frames aren't quite adequate so you may need to run a jumper wire to the main ground wire of the…

The inner diameter of bearing #L44649 is 1.063 inches. The inner diameter of bearing #L68149 is 1.378 inches. Both fit on a #84 spindle. The matching race for bearing L44649 is #L44610. And the matching race for bearing L68149 is #L68111. These…

I have contacted the two manufacturers but I have been unable to confirm the compatibility of the rotors from one company with the calipers from the other. Depending on how tightly and for how long the original calipers have been frozen in their…

The Dacromet-Coated brake calipers included with the Titan #T2HRCM10DAC Premier Disc Brake Kit do indeed feature stainless pistons and guide bolts. The exterior of the caliper and the rotors are Dacromet coated for corrosion resistance.

Yes, there should be a washer of some type between the spindle nut and the bearing on your trailer. The washer protects the back side of the bearing from the edges and points on the back side of the spindle nut. There are several types of spindle…

Hubs and drums that can be turned (machined) will have a specification on how much they can be turned cast into the metal of the drum somewhere. Otherwise it is at the brake shop's discretion. Drums do not have to be turned unless there is some…

All of that is not necessary. All you have to do is lock out the surge coupler so it cannot move in and out or disconnect the brake lines. By removing the old coupler you would have to remove the brake lines any way. A surge coupler can still be used…

The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-20 would be a great choice for an actuator to replace the surge actuator on your swing away trailer. You may need a new flexible brake line replacement as well with the part #T0980100 as well.

For your inner bearings and grease seals, if the reference number cannot be located, having an accurate measurement of both the inner and outer diameter of the bearing and seal will be very helpful in finding a replacement. A digital caliper is…