JR Products Snapper Coupler Pin Review Video

Thank you for the photos! It looks like Marvel used to be associated with Atwood and they went out of business a while ago. We have some similar coupler styles but I'm not seeing that any of our repair kits having the same design as your coupler…

The Demco #DM12688-95 you've looked at would be a good choice. The 2 inch channel mount coupler is compatible with a 3 inch channel, and has bolt spacing of 2 inches on center. Demco is known for high quality products, you'll get years of…

There is pretty much a standard for channel mount couplers such as #DM12113-95. The channel width is usually 3 inches and the couplers are usually around 2-7/8 inches wide to fit in the 3 inch wide channel. Once torqued down there is no side to side…

Adjustable trailer couplers are not going to mount to your truck; they will attach to the frame of your trailer. Some of the adjustable couplers, such as the Bulldog Cast Head #BDA2563C0317 come with the mounting hardware to weld onto the frame of…

When mounting a cast head coupler like Bulldog #BDA256C0317 to its mounting channel you will want to torque the mounting bolts to the specification indicated by the manufacturer in the instructions. The torque spec will vary from coupler to coupler.…

For the clearance light part #AL91RB we have the grommet part #A91GB which is basically a hard rubber.

There is! To replace the standard pin and clip on the Curt QuickPin No Latch A-Frame Trailer Coupler #C84DR Curt actually recommend the Hitch Lock #C23025 which is what I recommend going with!

I have a solution for you but we do not have a 2" square u bolt kit for a 3,500 lbs square axle that is 5 3/4" long. You will need to buy the u bolts and u bolt plates separately. The Square Trailer U-Bolt item #SP01-160 comes in a 2 pack,…

Since the diameter size of the posts on this u-bolt is 9/16-inch you can ideally use a 9/16-inch or 5/8-inch bit (or even a 1/2-inch bit if you have the room to move the drill around enough to ream the hole to the required size). In either case you…

Thanks so much for the photos, and there isn't a replacement for just the front coupler portion of the long-discontinued coupler you have. So in order to switch out from a 2" to a 2-5/16" coupler attachment, you will need to replace the…

Bulldog Heavy-Duty Cast Head A-Frame 2-5/16-Inch Coupler #BD44150WH301 is intended for standard 50-degree a-frame trailer frames. This unit is a bolt-on item and its rated 15,000-lb capacity is based on it being installed using all mounting holes to…

You can back up a trailer with a weight distribution system installed on as long as you don't end up in too tight of a turn. This is especially true with the Curt Weight Distribution System part #C17422 as it has a friction sway control system as…