Easy Swivel Trailer Jack Installation Video

Yes, I can confirm that the 24x40 etrailer Cargo Carrier for RV Bumper #e99050 does include the bumper safety struts #MO22FR you're referencing.

Running a direct ground up to the trailer tongue or junction box would certainly work, but the only time I'd see that as being necessary is if the lamps were connected to a non metallic structure or a metallic structure that wasn't…

Since you have 14 inch trailer wheel the studs of your hubs would be 1/2 inch which is a very common lug nut size. You don't actually have to switch lug nuts to go from steel to aluminum wheels though (or vice versa). Aluminum wheels have…

There is not an option to get only the cargo carrier without the brackets for the 24x40 etrailer Cargo Carrier for RV Bumper #e99050. I have added a link below to a video review for you to check out as well.

The Folding, Bumper Mounted Tire Carrier #TR-2 that you referenced comes with a mounting bolts and nuts to attach your trailer wheel and tire to. That being said if you wanted to you certainly could use hardware from a parts store.

When aligning the axles on your Trailstar Trailer, I recommend aligning them so that they are square to the trailer's frame. Doing this will maintain the load capacity and structural integrity of the trailer itself. If you were to instead align…

You may be able to reuse the same shackle bolts provided that they are the correct size, are not severely rusted, and are not cracked or otherwise damaged, but not the lock nuts. If you think your bolts might be rusted, cracked, or damaged I would…

Building a single axle trailer you will need the following items to install leaf springs. I have listed the part numbers for the PR626 Springs next to the items needed. 2 Springs - #e27SR 2 Front Hangers - #115917, 1-1/2 inch tall or #28-5, 3-1/4…

On the Redline Rear Hanger, part #30-20, which is the rear hanger included with kit #APS1, it is welded to the trailer with the side marked top, facing the outside of the trailer with the word top showing. So the U-shape part is what gets welded to…

The dimensions of Redline Rear Hanger with Bushing for Single Axle Trailer Suspensions #30-20 are 2-1/8 inches long, 1-3/4 inches wide, and 3/16 inches thick. I have provided a video and a graphic that shows these dimensions as well. I am also…

On the Redline Rear Hanger, part #30-20, the hanger has top stamped into one of the sides of the hanger. The hanger is welded to the trailer with the side marked top, facing the outside of the trailer with the word top showing. I am including a…

For a tandem axle trailer that uses 25-1/4 inch long leaf springs like #e57SR and a 7-3/4 inch equalizer like the TruRyde #TREQE1, the hanger spacing should be approximately 29-1/2 inches. Keep in mind that this is simply a starting point and…