Valterra RV Sewer - Waste Valves - T50A Review Video

You are correct that the 8000lb rating that the MORryde Rubber Equalizers for Tandem Axle Trailers - 33" Wheelbase - 8K #MR87ZR has is the maximum axle rating, and they would work perfectly with your 6000lb axles. Now to determine if these…

The Valterra RV Waste Valve, part #T50A, consists of both the 3-inch valve spigot and the 3-inch bayonet outer cap. You can see this item in the linked review video.

The LaSalle Bristol Cable-Actuated RV Waste Valve part #34466N4BB72GM comes with everything that you need to attach it to the factory handle holding tab. You will need to reuse the bolts that hold the valve in place in the waste pipe (or glue it in…

According to my LaSalle/Bristol representative, neither the valve size itself nor the spacing of the holes for the mounting hardware have changed over the years. The mounting holes are 3.73 inches apart center to center, which is right between 2-5/8…

The brackets which hold the rear bumper to the trailer frame are not always up to the task of hauling extra gear. In order to confirm we must recommend reaching out to the trailer manufacturer to see if and how much you can carry. If it's not…

From the flange of the Valterra RV Sewer Elbow #T1035-1 out to the furthest point out on this measures 5-1/2 inches.

The Valterra Waste Valve for RV Black Water Tank, #T50A has a 3" inner diameter measurement with a 3-1/2" measurement for the outside.

The difference between the Valterra RV Waste Valve #T60, and the Valterra RV Waste Valve #T60A, is that #T60 is a 3" Hub, and #T60A is a 3" Spigot. The difference between a spigot and a hub, is that a spigot is something that is to be…

So the difference is purely in how the two connect to your sewer pipe, which will also tell you which one you need; one will slide into the pipe (the spigot) while the other will slide onto the pipe (the hub): - Slide Into Pipe: Valterra Waste Valve…

Thank you for the photo, and there should be sensors with a monitor for your tank that tells you how full it is in order to use the Flush Valve for RV Holding Tanks and Sewer Hoses #F02-4350. If you don't have that, you can still use the Flush…

According to Solara (Lippert), the correct number of turns to set the proper tension of their slide toppers like #LCV000163285 is between 12 to 16 turns, so I'd consider 14 to be a pretty good happy medium.

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…