Flange to Furthest Point Out on Valterra RV Sewer Elbow # T1035-1

Question

Question:

What is the measurement from the flange straight across to the outside furthest point?

asked by: Daniel S

0

Expert Reply:

From the flange of the Valterra RV Sewer Elbow # T1035-1 out to the furthest point out on this measures 5-1/2 inches.

expert reply by: Jameson C

0

Flange Dimension
(click to enlarge)

Answer 1

I went ahead and found a wiring diagram for the Single Slide-Out Switch #37212285, and you are going to need to just match the hot from your trailer to the power (+) pin, and then match the green and blue wires to the motor (+) pins. I have…

view full answer...

Answer 2

Yes, the Lippert Slide-Out Switch Assembly #LC117460 would work as a replacement for your current switch, but I would definitely check out the wiring running to it to ensure there wasn't additional damage. I've attached a diagram…

view full answer...

Answer 3

The measurements taken of the Valterra Bladex waste valve, part #T40B, are of the complete length. You can see the measurements taken towards the end of the video I linked for you.

view full answer...

Answer 4

Unfortunately LaSalle Bristol completely covers the connection point in plastic so the only way to gain access to gate inside the LaSalle Bristol Cable-Actuated RV Waste Valve #34466N4BB96GM would be to cut into the plastic for the cord and…

view full answer...

Answer 5

It sounds like you have a lot of up and down movement in your travel trailer while going down the road. The Road Armor Shock Absorbing Kit part #LC696740 is a better option then the MORyde kit to help eliminate some of that movement because it…

view full answer...

Answer 6

The attached image was helpful in easily identifying exactly what measurement you wanting on the Valterra RV Sewer Elbow with Rotating Flange, #T1035-2. It is 5-5/16".

view full answer...

Answer 7

For an Advent Air RV Air Conditioner #ACM135 an E5 error typically indicates a communication error between the controller and the thermostat, but it can also indicate an issue with the thermal probe. The thermal probe is typically latched onto the…

view full answer...

Answer 8

Looking at the picture you provided it's either the Valterra Street DWV Fitting for RV Sewer System - 90 Degree - 1-1/2" Spigot to 1-1/2" Hub Item #D50-2880 or Valterra Street DWV Fitting for RV Sewer System - 90 Degree - 3" Spigot…

view full answer...

Answer 9

To install the Valterra Cable with Valve Handle #TC72PB you will need to simply follow the instructions that are included in the packaging: Remove the locknut from the cable housing assembly. Feed the cable through the mounting bracket or hold in the…

view full answer...

Answer 10

According to Jensen, resetting the stereo should fix your problem. Just to the right of the CD/DVD eject button is a small hole. If you straighten out a paper clip and push it in that hole, there's a small reset button. Press the button and the…

view full answer...

Answer 11

That's a pretty low trailer you have. To compute the correct amount of drop you would need you need to measure from the top of the hitch opening to the ground and from the bottom of the coupler to the ground. Based on the dimensions you just gave…

view full answer...

Flange to Furthest Point Out on Valterra RV Sewer Elbow # T1035-1

Product Page this Question was Asked From

Continue Researching