Ultra-Fab Products Camper Jack - Leveling Jack - UF48-979002 Review Video

The etrailer Scissor Jacks part #TJSCHD-24-4 would work great on your Keystone Premier Travel Trailer. It has more than enough capacity as it's rated for up to 10k and has a universal mount design that will fit your trailer.

We actually carry the replacement fuse part #EJ-FUSE for RAM or etrailer.com trailer jacks, like part #EJ-3520-BBX. With that being said, I have reached out to RAM about this in the past and they have said that there isn't anything special about…

There really isn't a difference between the intent and purpose of the Ultra-Fab Ultra Scissor Jack #UF48-979006 and the Lippert Scissor Stabilizer Jacks #LC285326. One just has the word Stabilizer in the title and the other does not. Both will…

Sounds like the screw or the motor of the Lippert Smart Jack #LC643589 is damaged or has an internal issue. The switch is obviously working and the motor works in the harder direction so something funny is wrong with it. If it's within a year old…

We highly recommend against double towing and many states either don't allow double (some states call it triple) towing or have numerous restrictions. Some states limit the total length of all 3 units, some only allow certain types of trailers…

The Scissor Stabilizer Jack #TJSC-24, which also comes in a 2-pack #TJSCHD-24 and a 4-pack #TJSCHD-24-4, is a universal fit so you would need to double check our measurements to ensure they fit your travel trailer. When they are collapsed they…

I spoke with MORryde and they said that the MORryde X-Factor Crossmember for Standard Frame Hangers #MR33WR will work just fine with your frame hangers with gussets. You'll just need to use the circled items attached in the image below and…

I went ahead and double checked to be sure, and yes the 7-Piece Installation Set for Bearings, Races, and Seals #PTW83020 you mention will work with your Timken bearings, races, and seals. If you don't have grease yet, you're also going to…

The part of a hub/drum assembly that makes contact with the electromagnet, the armature surface, cannot be machined. If the surface is deteriorated you'd do well to replace that hub. The link provided will show you all hub/drum assemblies which…

The Dexter Trailer Brake Assemblies 023-476-00 will cross-reference to our Dexter Electric Trailer Brake Kit part #K23-472-473-00.

It sounds like your problem may be that you are installing too much grease into the hubs and that is why they are blowing out. If you are pumping your grease into your hub with a grease gun you should note that you should only continue to add grease…

As long as your spindles are 4.75 inches from seal to threading like #TRU24FR or #TRU57FR they are compatible. I've attached a photo to assist. You will be able to use the Electric Trailer Brake Kit - Self-Adjusting - 10" - Left and Right…