Stromberg Carlson Leveling Scissor Jack Review Video

It is plastic. The ComeUp UW-5000si Trailer Winch item #CU645010 is a light duty winch so it's housing and base are made of plastic. I attached a picture below that will show you the base. I've also linked an installation video that will go…

The Redarc Tow-Pro Liberty Brake Controller #RED24FR requires a 7-way in order to activate the brakes on your trailer. It is not tied to the lights on the trailer at all. The blue brake output wire which runs to the 7-way at the rear of the vehicle…

The Leveling Scissor Jack - 24" Lift - 5,000 lbs #JSC-24-IND you were looking will likely work on your 2017 Rockwood HW276 Tent Camper, but you will need to verify that the amount of lift is correct for your specific trailer. The #JSC-24-IND has…

Typically, the blue wire on a 6-way connector is used to carry the output voltage from the brake controller. The 12-volt auxiliary feed, which usually feeds the center pin on the trailer connector can be used to maintain a fully charged battery, but…

The manufacturer does not have a schematic for the Stromberg Scissor Jack #JSC-24-IND, so I went to the warehouse and pulled one and came up with the following dimensions which I have noted in the attached picture.

We have the perfect winch for you to pull your 3,000 lb car onto your trailer, the ComeUp UW-5000si Trailer Winch #CU645010. This 5,000 lb static load/50,000 lb rolling load winch has a wireless remote (which is also waterproof) that will let you…

The Scissor Stabilizer Jack #TJSC-24, which also comes in a 2-pack #TJSCHD-24 and a 4-pack #TJSCHD-24-4, is a universal fit so you would need to double check our measurements to ensure they fit your travel trailer. When they are collapsed they…

I think I have come up with a unique method that could potentially keep snow from getting into the e-tracks you have installed on your snowmobile trailer. What you could do is use an e-track strap, such as #SLLS28CER, and attach one end to the last…

The Ark Drop Down Corner RV Stabilizer Jacks - 2' Long Corner Steadies - Qty 2 #AR34FR you were looking at does not have a weight rating, as they are not designed to hold or lift the weight of your trailer. They are instead designed stabilize…

There are a couple reasons why you typically see the axles on a horse trailer further back than on a standard cargo or flatbed trailer. The first reason is to try and maintain the trailer's weight distribution as best as possible during travel.…

I can't say that they're universal but many are compatible. I've provided you with a photo showing the hole spacing so you can compare your brackets to see if the Stromberg Carlson #JSC-24 stabilizing jacks will fit. Ultra Fab also offers…

If you are needing to completely remove the spindles on your trailer and replace them with new ones the old ones just need to be cut off. These are welded directly to the axle so you will need to use a torch or saw for this process. When installing…