Dutton-Lainson Trailer Winch - Standard Hand Winch - DL14725 Review Video

I believe I understand what you are asking for on the BoatBuckle Boat Winch Strap #IMF17741 and the dimension is 5/8 inch. Since it's harder to describe like you mentioned I attached a picture that has this dimension as well. If you were looking…

Since we do not have a Shelby jack mounting bracket that goes to the discontinued Shelby Jack #5876A8, I have no way to confirm whether or not a Fulton jack will fit it. With that being said, the Fulton Bolt-Thru Swivel Marine Jack #F1411300301 is…

Thanks for the picture of your trailer jack! Based on that all you need is the part #FXP100W0301 which will easily attach to the welded on bracket you have on your trailer frame.

We don't have the dimensions of the weld-on mount for your Shelby jack, but it looks similar to the Jack Mounting Bracket for Fulton Marine Jack - Weld-On #P9012-00. That mounting bracket uses a 1/2" bolt with pin holes measuring 3"…

Shackle straps can actually flip if they're too short as opposed to being too long, so it makes sense because you mentioned you put on shorter, 2-1/2" shackle straps. Also, if the leaf springs you replaced are shorter than what you had (…

The Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers #K71-448-00 will work with tandem-axle trailers with a 1-3/4 inch double eye spring. The equalizers are 4 inches tall and are 6 inches long from center-hole to center-hole. The shackle…

How did you measure the existing springs? Because leaf springs will flatten out over time as they wear, the best way to get an accurate measurement of the eye-to-eye length is with the trailer up on jack stands so the axle hangs free. This should…

The Fulton Winch Model 228 is a very old model and there will be no direct replacements for this. I recommend simply selecting a winch that meets your weight and mounting requirements. The Fulton Single Speed Trailer Winch part #F142101 for example…

I went out to our warehouse to take a look at the Fulton Replacement Bolt-On Mounting Kit #F500349 referenced in your question. I measured a distance between the two outside bolt holes, horizontally, of right at 5-1/2 inches. Vertically the distance…

In order to find the correct replacement leaf springs for a trailer you first need to start by noting the type whether that be slipper or double eye. Then, you'll need to measure their unloaded length via jacking up the trailer. If the springs…

There's no issue going from a Load Range C tire to a Load Range D like with the #AM10208 that you referenced. Have additional Load Range/capacity really has no adverse affect on anything so this would not be an issue.

A Kenda Karrier ST185/80R13 Radial Trailer Tire #AM10208 will have an outside diameter of of 24.7" when mounted and inflated. This is the same size as your 185x13 trailer tire.