Fulton Trailer Winch - Standard Hand Winch - F142401 Review Video

I do have a video for the Fulton #F142401 which is nearly identical to the #F142400 that you were looking at. The only difference is that the #F142401 can be used with a strap or wire rope, while the #F142400 can be used with rope only. Other than…

Whereas the Fulton #F142400 will work with just wire rope, like the #FWC3250100, the Fulton #F142401 will work with wire rope and also a strap, like the #FWS20HD0200. With both of these having a capacity of 2,000 ponds and being high performance 2…

The 2-Speed Boat Trailer Winch part #315-W3200D is an excellent upgraded 3,200 lb winch for a boat trailer. In regards to mounting, not all winches use the same pattern so you'd need to compare the dimensions in the photo below to what you have…

I've attached two pictures of the bolt pattern of the Fulton Winch #F142401. One shows the size of each bolt hole and the other shows the distance between the holes.

The size winch that you will need depends on a couple of different factors. I have included part of our hand winch FAQ below regarding boat winches and have linked the FAQ article for you to view. Finding the Right Capacity Winch for your Boat…

I went out into our warehouse to grab a Dutton Lainson Winch part #DL14627 to measure the bolt hole dimensions for you. I attached a picture that has all of them listed.

The base on 2-Speed Boat Trailer Winch #315-W2500D measures 5-3/4 inches wide by 7-1/8 inches long. This is a very standard size and bolt pattern so it should fit on your trailer easily. I attached a review video for this for you to check out as…

I had the Fulton XLT 2-Speed Trailer Winch #F142425 measured and have a picture included with the corresponding measurements. Red: 2-3/4" Blue: 4-1/8" Green: 5-3/4" Pink: 6-7/8"

I took a look at what we have for your Fulton T2005, and it turns out that this winch has been discontinued and unfortunately there is not a replacement for it, however I do have another alternative. Instead, I recommend upgrading your older T2005…

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

The mounting plate for the Fulton XLT Bolt-Thru Swivel Trailer Jack #F26ZR has the following dimensions. I have included an image to show the measuring points. The holes are spread 5-1/2" wide with the vertical holes separated 1" on the…

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…