Brophy Safety Chains and Cables MB38 Review Video

To make sure the Ark Extreme Off-Road Swing-Up Trailer Jack #ORJW750BD will fit your trailer, there will be two things that need to be confirmed. First will be the tongue weight of the trailer you want to attach it to. This has a static, or resting,…

First, I would say if there is any question on the road worthiness of the trailer, take the steps to correct it. Better safe than sorry. Some trailers have wheels that are hub-centric, the wheel is centered on the hub using the center pilot holes.…

Most A-Frame Trailer Couplers have a standard of 50 degrees. I produced a short video for you showing the angle of the etrailer A-Frame Coupler, part #CA5400. I have also linked an FAQ on trailer couplers.

All of the A-frame couplers we carry are for the standard 50 degree A-frames. What you could do, since your A-frame is a lower angle, is have some steel spacers welded on to get to 50 degrees and then use a weld-on coupler. I have linked the weld-on…

The etrailer Weld-On A-Frame 2-5/16-Inch Coupler, part #CA5400, does not have any adjustment screw to enable you to take up the slack in the fit with your hitch ball. This coupler is produced by a stamping process and this type of manufacturing…

There are no repair kits available for the A-Frame Coupler #CA5400, so the best we can offer is to replace it with the same or, if you don't want the oily finish, the A-Frame Trailer Coupler #CA-5400-B.

The parts you all mentioned would have enough capacity for the weight of your 9.9k toy hauler. The part #MB38 would work well for mounting the safety chains #49150 with the quick link #C82932. Now where the part #MB38 should install on your trailer…

The auxiliary 12-volt wire that runs from the 7-way connection to 7-way trailer plug will supply 12-volt power from the vehicle to the trailer. The 12 -volt power will allow interior or exterior lights to run that are not wired in to the…

If you are talking about not having room for a bolt-on application for your safety chains to connect to then we do have a solution for you! Attached is our list of safety chain mounting brackets that are weld-on applications. Simply filter through to…

Thank you for the photo of your utility trailer that appears to already have safety chains installed near the coupler. Safety chains should be selected based on trailer weight and on the length you need. If your trailer has a 3500-lb-rated axle then…

Typically, two of the safety chain brackets would be used. Given the 1-1/2 inch by 3/4 inch size of the loop (see photo), I doubt that two separate chain links would fit. If the links of your safety chains would slip over a 5/8 inch rod, the…

You should not weld the chain directly to the trailer. There is no federal law about weight or size rating on safety chains. You will need to check with your local DMV office for the requirements in your state. If you are needing a mounting point for…