Review of etrailer Trailer Fenders - Single Axle Fender with Backing Plate - HP36VR Video

You want to make sure the hangers on your trailer have the same width as your leaf spring so if your leaf spring is 1-3/4" wide then you don't want to use a 2" or 2-1/2" wide hanger. It's true that you want the hanger bolts…

I can understand that if your boat is loaded on the trailer, you don't want to remove one of the wheels to measure the fenders. Measuring a fender with the tire still mounted can be tricky, but it's not impossible. I've provided a diagram…

You are indeed right to think this way. When picking out the appropriate leaf springs for your custom built trailer you will want to choose them based on what the actual loaded weight of the trailer will be. Just make sure that the leaf springs have…

The 2x2 inch square axle is likely 3,500 lbs or less capacity. I would need more spindle dimensions or bearing numbers to assist. If you pull a hub and measure at the spindle where the bearings and seal ride using the digital caliper like #PTW80157 I…

When replacing the leaf springs on your boat trailer you will need to match all of the dimensions and the spring capacity as closely as possible to the original spring. Usually the measurement from eye to eye will lengthen and the height measurement…

I am not really sure what the dealership was referring to as a 22 axle but we do have options for you to lower your trailer. The first option if you have a leaf spring axle is an over/under kit like the Dexter Trailer Springs Over-Under Conversion…

When it comes to lowering your trailer 2-2.5 inches if your have leaf springs and they're positioned above the axle tube, you can flip them with the Dexter Trailer Springs Over-Under Conversion Kit #K71-385-00 if you have a 3 inch diameter axle…

The steel backing plate on etrailer brand trailer fender #HP36VR is tack welded inside the rear lip of the fender. This backing plate, shown in the linked photo, does NOT extend all the way down to the very bottom of the fender. I went to our…

Trailer tires that are not yet installed and that are kept in a controlled environment will not suffer significant deterioration after only a few months. In a typical retail environment tire inventory will cycle through every 3 to 9 months. Tire…

The bolt hole spacing for the CE Smith Front/Rear Hanger Bracket for Double-Eye Springs #CE14026G is 4-3/8" x 1-5/8". I've attached a dimensional photo for you to check out as well as a review video to reference.

The best way to choose the correct replacement leaf spring for a trailer is to measure the existing spring. If this cannot be done however then you can get a good idea of what the spring length will be based on the hanger spacing but this is not as…

I can absolutely confirm the correct lift kit for your trailer. Based on your photos, you do in fact have a #10 Torflex axle, and they are compatible with the lift kits because you do not have 3" high-profile brackets (which just means the…