Review of B and W Trailer Hitch Ball Mount - Tow and Stow Pintle Hook 2-5/16 Inch Ball - BWTS10056 Video

I have attached an image of the Draw-Tite Ultra Frame Trailer Hitch Receiver #41947 referenced in your question with a few dimensions labeled. The distance between mounting holes, from the left side mounting bracket to the right side mounting bracket…

I have attached an image of the Draw-Tite Ultra Frame Trailer Hitch Receiver #41947 referenced in your question with a few dimensions labeled. The distance between mounting holes, from the left side mounting bracket to the right side mounting bracket…

Draw-Tite trailer hitch #41947 is a custom fit hitch designed for specific vehicles and should not be used on any applications it was not designed for. The trucks it does fit on would have approximately 37 inch frames measured from outside to…

The Draw Tite hitch part #41947 has been confirmed as a fit for your 1999 Chevy 3500 that is built on a cab and chassis frame that is 34 inches apart. It has the cutout in the mounting flange to clear the spring hanger like you said you needed as…

The horizontal mounting plate that mounts to the frame of your vehicle on the #41947 is 2-13/16" wide and the mounting plates themselves are 11-9/16" tall. The holes on the horizontal mounting plates are 3/4" and 1-1/4" in…

Draw-Tite custom-fit Class V hitch #41947, which fits trucks with an outside-to-outside frame width of 34-inches, can be installed at any of three heights, thanks to the multiple holes in the two frame brackets. I can give you these heights…

Basically, a weight distribution system moves some of the load up the vehicle frame so that the front suspensions bears some of the weight. Weight distribution spreads some of the weight from the rear axle to the front. An air bag system spreads the…

We do not offer any wiring adapters to convert a 12-pin female connector on a military vehicle to a standard RV-style 7-way like #37185 or a 4-pole like #18252. But you can install a different type of trailer socket on the truck by hardwiring one.…

If used in the rise position, the #63058 pintle hook mount would measure 11-1/2 inches from the bottom of the shank to the top of the plate. The tailgate clearance will depend on how far above the top of the plate the pintle would extend. With the B…

Yes you can. If you got the B&W Tow & Stow Pintle Hook with 2-5/16" Ball #BWTS10056 you could use the #BWTS10051 as a replacement 2 inch ball when you needed it.

This is a really good question. I reached out to my contact at B&W to see if it was possible to use the pintle hook attachment from the B&W Tow & Stow #BWTS10056 with your 2-Ball Tow & Stow like #BWTS10037B and he said unfortunately…

I spoke with my contact at B&W and since the Silencer Pad, #BWTS35020, is a universal product, it will fit differently on each vehicle and some may need to use greater force in order to get the hitch pin holes on the ball mount to line up with…