B and W Ball Mounts - Adjustable Ball Mount - BWTS10043B Review Video

Yes, a trailer that is nose up can cause big problems. A level trailer is ideal and worth working toward for safety. The good news is that you can get the trailer almost exactly level with switching ball mounts. This is where an adjustable ball…

From the top of the shank to the bottom of the vertical section of the B&W Tow & Stow 2-Ball Mount #BWTS10040B measures 10". Then with the 2" hitch ball in the lowest position the 2-5/16" hitch ball will sit…

To route the trailer wiring connector outside on your 2011 Toyota Sienna you will need to find a grommet in the rear of the vehicle. I attached a photo showing a grommet that can be used in the cargo area of the 2011 Sienna under the carpeting. We…

The B&W Tow & Stow 3-Ball Mount #BWTS10049B measures approximately 5-1/4" from the top of the receiver to the top of the 2" ball when in the lowest position. Keep in mind that drop is measured from the top of the shank to the top of…

Yes, the B&W Tow & Stow 3-Ball Mount #BWTS10049B that you referenced will fit your 2002 Ford F-350 without any problems. It's designed to fit 2 inch hitches like what your truck has as well. I attached a picture of it installed on a…

The Rhino-Rack Artificial Rain Gutters #739A are a universal fit since you'd be drilling through the wall of the trailer and bolting them in place. The only issue you might have is just with the bolt length. If the wall is too thick then…

There are two pin holes on the B and W Tow and Stow ball mount #BWTS10043B that you referenced. Each has a different distance from the center of the pin hole to the center of the hitch ball. Hitch pin hole closest to ball: 10-1/4" Hitch pin hole…

It sounds like you want a fixed style ball mount. For that, I recommend the Convert-A-Ball Ball Mount for 2" Hitches - 8-3/4" Rise - 10" Drop - 8,000 lbs #AMSC10. This will give you the drop needed plus a little to allow the trailer to…

The only internal pieces that are replaceable on a Diversi-Tech ball mount are the lock cores like what you mentioned with part #DTLBM02RK. Since this is the case you will need to replace the entire ball mount. I know this isn't the news you…

The best option we have for a roof rack that would have crossbars 10-12 inches above the roof of the trailer would be with the Rack Em Trailer Ladder Rack part #RA-28 which was designed for enclosed trailers but has the taller towers/feet. There…

I do have an option for you but roof rails won't work very well on a teardrop trailer, even if you were able to get the rails to conform, it's likely the accessories would bind due to the steep angles. Instead, you will need to use artificial…

Determining how to get the correct rise or drop is actually pretty simple and only requires two measurements. If you get the largest rise and drop you could wind up with more ball mount than necessary. In order to choose the correct ball mount, there…