Dimensions of Draw-Tite Ultra Frame Trailer Hitch Receiver # 41947

Question:

What is inside width

asked by: Mike

Expert Reply:

I have attached an image of the Draw-Tite Ultra Frame Trailer Hitch Receiver # 41947 referenced in your question with a few dimensions labeled.

The distance between mounting holes, from the left side mounting bracket to the right side mounting bracket is 30-1/2 inches. The distance between the mounting holes, center to center, is 3-1/2 inches for the closer of the two holes and 15-7/8 inches from the hole nearest the receiver to the rear bracket hole.

expert reply by: Jameson C

click to enlarge

Bill M.

4/1/2020

What is the measurement from the top of the 2” by 2” ball mount tube to the top of the hitch mounting hole flange vertical distanceThank you,

Chris R.

4/1/2020

The crosstube on the Draw-Tite # 41947 can actually be adjusted along the frame brackets, so there are 3 possible answers to your question depending on where you set it. From the top of the bracket to the top of the receiver tube, there can be a distance of 6-5/8", 8-1/4", or 10-1/4".