Search: trailer couplers   >   Fulton  x   >  

The DeeMaxx Disc Brake Kit #DE82FR comes with 2 Slip-on rotors, calipers and brackets for one axle. The slip on rotors are for a 6 on 5-1/2" idler hubs and the mounting brackets fit on a 5 bolt brake flange.

First, make sure that you have the correct size Bearing Buddy. It should be slightly larger than the hub bore though it is difficult to tell just by looking. If you can tell me the outer bearing number I can determine which is the correct model.…

The Dexter 8-133 axle according to my contact at Dexter is an old motorhome axle they no longer make. Their tech said the motorhome axles like what you have are designed for one time use so there are not compatible parts made for even replacement…

Because the Retrax PRO MX Tonneau Cover #RT80467 for the 2019 Chevy Silverado 2500 covers the bed rails, you would not be able to use a ladder rack like the Thule TracRac #TH27000XT since that rack requires the use of the bed rails. The only tonneau…

I looked up the information on your TDE 46205 Hubs and found a couple of great replacements for you. The one you pick will depend on the number of wheel studs you have. For 5 wheel studs use the etrailer Trailer Idler Hub Assembly for 2,000-lb E-Z…

The nut on the spindle should be tightened until snug, with no side-to-side play in the hub and then backed off slightly, about maybe a 1/8 of a turn. If the spindle uses a castle nut and cotter pin or tang nut, tighten the nut finger tight until it…

Since one end of a slipper spring is suspended instead of bolted to a hanger or shackle strap the Dexter Trailer Springs Over-Under Conversion Kit part #K71-385-00 and other likes them are considered unsafe for slipper springs. The only other option…

Yes, I do have the exact dimensions you need of the Demco Channel Tongue Trailer Coupler part #DM15945. I have attached these for you below.

The Dexter 8-283 is an obsolete 2800lb 10 x 1-1/2 inch hub that used a LM67048 inner and a L44649 outer bearing. Unfortunately, we don't have any hubs that would be compatible with the spindles on your axle. Your best bet at this point would be…

The outer thread diameter of the #K71-859-00 that you referenced is 3-3/4 inches so this would work for you based on what you mentioned.

I do have an option for you but I cannot give you exact bearing numbers for your trailer unless provided with spindle measurements or the trailer's VIN (if the manufacturer is still in business). I can however tell you that the two most common…

We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…