Demco eZ-Latch A-Frame Trailer Coupler Installation - 2020 Taxa Mantis Travel Trailer Video

Yes, you can remove your weld-on coupler and install a new bolt-on coupler that fits a 2 inch ball. There is just a few things you need to do to before and when installing. You need to know what channel size and the weight capacity you will need…

If you look at the diagram that I received from my contact at Demco, you can see several of the dimensions of the #DM14793-81 trailer coupler. If there were other dimensions you were needing, please let me know.

The only differences between the Demco eZ-Latch Couplers #DM37ZR and #DM14793-81 is that the former has integrated loop holes for installing safety chains and a about a 2" drop while the latter doesn't come with provisions for…

Nearly all A-frame trailer have a 50 degree angle frame, the Demco A-Frame Trailer Coupler #DM14793-81 that you referenced has a 50 degree angle too.

For your 5x10 foot trailer, I recommend the HitchMate StretchWeb Cargo Net with Hooks - 6' Wide x 10' Long #HE4256. This net is large enough to cover your trailer when fully loaded and is adjustable with the clips for securing smaller…

Nearly all A-frame trailer have a 50 degree angle frame, the Demco A-Frame Trailer Coupler #DM14793-81 that you referenced has a 50 degree angle too. I would be surprised if your trailer had a different angle, but to be sure you could use an angle…

Generally the Demco A-Frame Trailer Coupler w/ Jack Hole part #DM14793-81 is very easy to release. There is a lock/pin hole located just under the latch that may have a pin in it preventing it from opening. I have linked a photo showing exactly where…

Thank you for the photo of your 1973 Sprite Alpine travel trailer which has an unusual integrated coupler and jack. Truthfully, this is the first time several of us have seen this kind of setup. What I recommend is a cost-effective bolt-on…

I checked the Featherlite Trailer website for specs on the model 3116 trailer but this part number returned no results. But if your trailer uses an industry-standard 50-degree a-frame design then the Demco A-Frame Trailer Coupler #DM16680-52 will fit…

I walked out to our warehouse and pulled the Redline A-Frame Trailer Coupler #CA5100B. At the widest point inside the coupler measured approximately 9-1/4 inches, the narrowest approximately 2 inches and 8 inches between those points. Check out the…

From the rear of the coupler portion on the Demco A-Frame Coupler #DM14793-81 to the center of the center bolt hole there is a distance of 4-1/2 inches. From the rear of the A-Frame mount to the center of the center hole there is a distance of 4-3/4…

Only solution will be to extend out the frame rails of your trailer so that you can install a standard coupler on to them. None of the options out there are going to be large enough to fit your frame channels that basically start too far apart. What…