Does The DeeMaxx Disc Brake Kit # DE82FR Include Both Brakes For One Axle?

Question

Question:

Does this come with 2 kits to do one axle?

asked by: Gideon L

0

Expert Reply:

The DeeMaxx Disc Brake Kit # DE82FR comes with 2 Slip-on rotors, calipers and brackets for one axle. The slip on rotors are for a 6 on 5-1/2" idler hubs and the mounting brackets fit on a 5 bolt brake flange.

expert reply by: Bud M

0

Answer 1

The Dexter Brake Actuator part #099-175-20 replaced the Titan 60 that has a master cylinder with a fitting at the end. The fitting is a 3/16 inverted flare where the brake lines connect to. You do not need an extra fitting when you use the…

view full answer...

Answer 2

To bleed the brake lines on a Titan Zinc-Plated Brake Actuator #T43397007K I recommend using the Powerbuilt Brake Bleeder #ALL648591. This has a magnet that will hold the catch container where it is easily visible. Using the 4 steps detailed in the…

view full answer...

Answer 3

The Kodiak Disc Brakes #KOD69FR will fit on 5,200lb axles which use the #42 spindle dimensions. This is the most commonly used size but depending on the age of your trailer you may want to inspect your spindle. It will have a grease seal landing…

view full answer...

Answer 4

The DeeMaxx Disc Brake Kit #DE82FR with the Maxx coating has a salt spray rating of over 1,000 hours while the DeeMaxx Disc Brake Kit #DE54VR with the Stainless construction isn't rated for salt spray, but when I spoke with the owner he said the…

view full answer...

Answer 5

Yes, the DeeMaxx Disc Brake Kit #DE66YR will allow you to use 14" trailer wheels.

view full answer...

Answer 6

The easiest solution I may have for you would be to use a triple axle brake line kit like the #20TR-BLKIT or #HS496-253 and route everything like the picture I attached.

view full answer...

Answer 7

I can help you determine what hubs and rotors will work to as replacements on your trailer, but I will need a bit more information. Additionally, it is best to replace the hubs and rotors for both sides of the trailer to know that you are getting the…

view full answer...

Answer 8

I believe you meant a TDE 46245, is that correct? If that's the case, you've got a 3500 lb axle which uses a 10 inch hub/rotor with a 5 on 4-1/2 wheel bolt pattern. You'll want to use the Kodiak #KHR10D hub/rotor as a replacement. The hub…

view full answer...

Answer 9

You will need the DeeMaxx Ceramic Brake Pads with Stainless Steel Back Plates #DE98VR to fit the DeeMaxx Disc Brake Kit DBSO-6K-MAXX #DE82FR. We also have the Stainless Steel Caliper #DE58VR if you want to upgrade your caliper.

view full answer...

Answer 10

The exact placement of the hitch will depend on which installation kit is used. Generally speaking, fifth wheel hitches are installed so that the king pin will fall either directly over the rear axle centerline or within a few inches forward of that…

view full answer...

Answer 11

With any truck, the fifth wheel trailer's king pin should be positioned directly above or just slightly ahead of the rear axle centerline. The exact placement will depend on which installation kit you are using. If you were to place the king pin…

view full answer...

Answer 12

I can help you with greasing up your EZ Lube Axle. First thing I would check would be that the grease is not coming out of the back of the axle through the seal. If this is the case you will need to replace the seal. Our tubes like #L11390 have 14…

view full answer...

Does The DeeMaxx Disc Brake Kit # DE82FR Include Both Brakes For One Axle?

Product Page this Question was Asked From

Continue Researching