Bulldog Winch 400 Amp Shut-Off Switch - Removable Key

See what our Experts say about this Bulldog Winch Accessories and Parts

• Are Extra Keys Available For Bulldog Winch Shut-Off Switch?
  Replacement keys are not currently available for Bulldog Winch 400 Amp Shut-Off Switch - Removable Key # BDW20247. If you misplaced your removeable key then you will need to purchase a new shut-off switch kit.
  view full answer...
• Can Bulldog Winch Battery Disconnect # BDW20247 be Used on Travel Trailer
  Yes, the battery disconnect from Bulldog Winch # BDW20247 that you referenced will work great as a way to disconnect the battery of your trailer easily.
  view full answer...
• What is Amperage Rating of Bulldog Winch 400 Amp Shut-Off Switch # BDW20247
  The only amperage rating that the Bulldog Winch 400 Amp Shut-Off Switch # BDW20247 has is 400 amps which is the power circuit this can be used with.
  view full answer...
• Does 400 Amp Bulldog Winch Shut-Off Switch Fit Bracket of 200 Amp Shut-Off Switch
  The bracket of the 200 amp Bulldog Winch Master Power Shut-Off Kit # BDW20079 will not fit with the Bulldog Winch 400 Amp Shut-Off Switch - Removable Key # BDW20247. The Shut-Off Switch # BDW20247 does have holes on its base that are spread 2-1/2 inches apart on center which are used for mounting, but there isn't a bracket for this switch.
  view full answer...
• Battery Disconnect Switch to Use with Vermeer Chipper with Electric Starter
  We have two options for you to consider. We have the Bulldog 500 amp switch part # BDW20248 which would work well or we have the 400 amp switch part # BDW20247 instead which has a removable key on it which would act as a theft deterrent possibly. Both of these have mounting holes which will allow you to easily mount them as long as there's an available area on chipper but it's hard to be more specific than that as you'll need to provide hardware to allow this application to install the...
  view full answer...
• Recommendation for Wiring T 6V Batteries in Series with Disconnect Switch
  For your 2011 Monaco Monarch, the two 6 volt batteries will be wired in series so your output will be 12 volts but your capacity remains consistent. I recommend connecting your batteries using the Deka 2/0 Gauge Overmolded Battery Cable Harness Assembly - 7" Long # DW04362. You will run this between the positive terminal of one battery and the negative terminal of the other battery with the positive terminal of that battery providing output to your components. I've attached a diagram...
  view full answer...
  
• Does Putting an On and Off Switch on an Everchill Refrigerator Void the Warranty
  I spoke with my contact for you at Everchill and on your Everchill Refrigerator for RVs - 12V part # 324-000119 they do not recommend adding in your own switch. That being said they would likely give you trouble if you had any issues with the unit. Not all hope is lost here though. I have a couple of solutions for you. If you're only trying to shut down the refrigerator then you can locate the fuse in your power distribution center and pull that fuse. That will stop power from being...
  view full answer...
• Shut-Off Switch Needed for Recovery Winch
  If you are anticipating needing a switch that is rated for 350 amps then we will need to find you a different switch as the Master Power Shut-Off Kit # BDW20079 is only rated for up to 200 amps. For your application I recommend using the 500 Amp Shut-Off Switch # BDW20248 or the 400 Amp Shut-Off Switch # BDW20247 which has a removable key. Neither of these options come with a mounting bracket like the one you mentioned but you could mount them to the Mounting Bracket # PK12711U which would...
  view full answer...
• Correct Way to Connect a Breakaway Battery and Winch Battery to 12V Power on Trailer 7-Way
  A diode like the part # RM-690 is a great idea but the only issue is that is has a max load of 85 amps. A standard 5,000 lb winch, like the ComeUp DV-5000si # CU645010, will greatly exceed the 85 amp rating of the diode so it would be useless. What you will want to do is install a battery disconnect like part # BDW20247 (400 amps max), part # BDW20248 (500 amps), or part # DW05312 which completely disconnects them. You can then reconnect the batteries once you are connected to your tow...
  view full answer...
• Battery Disconnect Switch for Forest River Surveyor During Storage
  You have a couple of different options when it comes to disconnecting the power from your batteries when your Forest River Surveyor is in storage and they all just depend on your personal preference as to which one is best for you. What you are likely referring to is something like the Epicord # 277-000096 which you rotate the key to the on and off position when you want to use the batteries for power. If you are looking for something a little more secure though we also have the Bulldog...
  view full answer...

Do you have a question about this Accessories and Part?