Optronics LED Trailer Tail Light Installation stl14rb Video

You have 2 options for your 25 Ft 4-Way Trailer Wiring Harness #A25W2GWB when wiring in the Optronics LED Combination Trailer Tail Lights #TLL160RK. First is the way I recommend since the harness has the full length ground wires is to cut off the…

The LED Combination Trailer Tail Light part #STL14RB for passenger side or part #STL15RB for drive side appears to be very similar if not the same as the tail lights on a 2019 Karavan Utility Trailer. That said, most of these tail lights fit the same…

We do indeed have some LED taillights that'd work great on your boat trailer. I'd recommend #STL57RB for the driver side and #STL56RB for the passenger side. These lamps measure 6-1/16 x 2-5/8 inches, and would work well on your trailer. As…

The LED Combination Trailer Tail Light part #STL14RB would be a suitable replacement for the passenger side tail light on a 2019 Bass Tracker Trail Star Trailer. If ever needed, we also have part #STL15RB for the driver side.

It sounds like you have a 7-way blade connector on your boat trailer as that is a very common connector on boat styles. This connector has 6 pins around the outside of the connector and a center pin for a total of 7. Part #A7WCB would be what a 7-way…

If your tail lights look like #STL16RB or #STL17RB, then you can use the Replacement Tail Light Lens, #A16RB. This is the correct replacement for the tail light. If the lens portion is deeper on your lights than those pictured, you may have a 26…

In order to get your trailer up and running you will have no other option but to replace the entire trailer jack as the inner tube is not a replaceable part. I am sure you have seen a few of the drop legs on our site which are replaceable but this is…

We have just what you need based on the dimensions you listed. The correct grease seal you need is the part #168255TB which has outer diameter of 2.561 and an inner diameter of 1.687 inch.

For the drivers side light to go along with the part #STL14RB that you referenced you would want the part #STL15RB. This is the matching light you are looking for.

We have just what you are looking for. I called my contact at TDE and asked about the hub you have on your boat trailer. They told me that it was a 5-stud idler hub for a 3,500-lb axle. That means you need the part #AKIHUB-545-35-K. This is a fit for…

Yes, the CE Smith Trailer Hub part #CE13511 will fit as a replacement for your DICO hub 45264 but you will need to use a different seal as we have found that your spindle diameter is slightly different which means you need the #168255TB as well.

There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a 3,500…