Curt Hitch Extender Review Video

The 1-1/4" hitch extenders available are all also expanders, the Curt Hitch Extender part #D189 for example which provides a 7" extension.

Yes, there is an aftermarket hitch available for the 2021 Kia Seltos with Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" part #C65FR. The installation process does not require any drilling into the frame of your Kia but it does…

When installing the Installation Hardware #LC373965 you do not need to drill. The hardware bolts over the frame like you mentioned.

The brackets part #LC373965 that you referenced basically either bolt around or weld to the bumper support beam on the RV. I attached a picture that shows them welded but you could also drill holes in the bumper and use included hardware to secure…

The wire that you see in the pictures for the Curt Trailer Hitch, #C11290, is called a fishwire or bolt leader. It is used to pull bolts and other hardware needed for hitch installation into place in hard to reach or otherwise inaccessible places on…

We have both Class II and III trailer hitches available for your 2011 Dodge Charger R/T. If you are going to use Class III hitch #C13093 then I recommend etrailer ball mount kit #989900. It comes with 2 ball mounts, 2 balls, a hitch pin with clip,…

I called my contact at Curt and asked about the Trailer Hitch Receiver, part #C12064. They said they could not guarantee it would fit your Hellcat. It is a Class ll hitch and has a 1-1/4 inch receiver opening. I also called Draw-Tite and asked about…

The Trailer Hitch Adapter #e93YR is the closest extender/riser to the Trailer Hitch Extender #e68YR you found. The adapter does change from the 1-1/4" receiver to a 2" receiver for the accessory. You would need the Reducer #e63YR to get…

The Draw-Tite Class II Trailer Hitch Receiver, #36548, will fit a 2016 Dodge Challenger if your vehicle does not have the quad-tip exhaust. Since your model is the Hellcat, I am assuming that your vehicle will have the quad-tip exhaust. I recommend…

I can confirm that a hitch like the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #C13416 will fit both the Hybrid and non-Hybrid versions of the 2021 Toyota RAV4 since the frames of the vehicles are the same. If you check out the…

The Brophy Hitch Extender, part #hes0, is a hitch extender that will extend out your 1-1/4 inch opening by 10 inches. The hitch opening on the extender is 1-1/4 inch. The #hes0 extender will accept the shaft of a 1-1/4 inch bike rack, but you we need…

An extender will reduce the capacity of the hitch, not your bike rack, by 50 percent. Your hitch is rated at 200 pounds maximum tongue weight, if you were to use an extender, your tongue weight capacity would be reduced to 100 pounds. Subtract 55…